CF-logo

CF 45 CL Robotic Cleaner

CF-45-CL-Robotic-Cleaner-product

SAFETY INSTRUCTIONS

  • Read the manual carefully, and use the cleaner according to the manual. We are not liable for loss or injury caused by improper use.
  • Only use the accessories recommended or sold by the manufacturer.
  • This model only applies to swimming pools with a flat floor.
  • Do not allow children to ride on the cleaner or play with it as a toy.
  • Use the original and authorized charging adapter only.
  • The adapter cord should only be repaired or replaced by a qualified electrician.
  • Do not turn on the cleaner when it is out of water.
  • The charging adapter must be connected to a leakage-protected and earthed socket when charging.
  • Do not operate the cleaner when there are people in the pool.
  • Always clean and wash the filter tray after use.
  • Turn off the cleaner when maintaining, cleaning,g or when it is not in use.
  • The cleaner should be stored in a cool and ventilated place, away from direct sunshine.
  • While charging, the cleaner should be kept in a cool place, and not be covered with anything
    to prevent the damage of internal electrical components caused by overheating.
  • Only certified professionals can disassemble the sealed driving kit of the cleaner.
  • Do not operate the cleaner while the pool filter is running.
  • Oil seals for motors contain grease, which may cause water pollution if grease leaks occur.
  • Due to the limitation of battery capacity, the cleaner is only suitable for swimming pools with sizes up to 525 ft2 (50m2 ), otherwise,e the cleaning effect will be affected.
  • When the cleaner is stored for a long time, it should be charged every three months to maintain battery life. Please use the original and authorized charging adapter only. If the cleaner is not charged for a long time, the battery voltage will be lower than the over-discharge
    protection voltage due to the self-discharge of the battery, which may cause fatal damage.
  • Do not use or store the cleaner near any heat source.
  • Do not pierce the shell of the cleaner with nails or other sharp objects. Do not hammer, impact, or throw the cleaner.
  • Make sure the charging socket is dry before charging.

INTRODUCTION

The environmentally-friendly robotic pool cleaner CF 45 CL is a new type of rechargeable automatic cleaner that filters the pool water and gets rid of particles without replacing the pool water.

PACKING LIST

CF-45-CL-Robotic-Cleaner-fig- (1)

PRODUCT DESCRIPTION

CF-45-CL-Robotic-Cleaner-fig- (2)

SPECIFICATIONS

CF-45-CL-Robotic-Cleaner-fig- (3)

ASSEMBLY BEFORE USE

  • Attach the flipper and fix it with the screws provided.CF-45-CL-Robotic-Cleaner-fig- (4)
  • Install the scrapers to enhance the suction effect if the pool floor is full of debris or particles. It is not recommended to install the scrapers if the pool bottom is uneven or full of pits, which prevents the cleaner from getting stuck on the rough floor.CF-45-CL-Robotic-Cleaner-fig- (5)
  • Attach the retrieving hook to a standard pool pole (not included).CF-45-CL-Robotic-Cleaner-fig- (6)

OPERATION

Charge the battery
Fully charge the cleaner before each use. Attach the charging connector to the charging socket at the bottom of the cleaner. Place the cleaner in its upright position and, then plug the charger into the main electrical outlet. The indicator lamp on the charger shall turn red when charging. It should turn green once fully charged.
NOTE: The robotic cleaner must be charged indoors.
NOTE: It is strictly forbidden to face the bottom up to prevent the swing plate from being crushed when charging.
NOTE: Clean and dry the charging socket before charging.CF-45-CL-Robotic-Cleaner-fig- (7)

Purge out the ai.r
Hold the robotic cleaner with two hands and submerge it into the pool. Rotate the cleaner until no bubble is coming out.CF-45-CL-Robotic-Cleaner-fig- (8)

Turn on the power
While keeping the entire robotic cleaner underwater, switch on the product by pressing the power button located at the bottom. Water will begin to flow out from the nozzle after 5 seconds.CF-45-CL-Robotic-Cleaner-fig- (9)

Release the cleaner
Hold the robotic cleaner in its upright position and slowly release the product. The product shall slowly sink to the pool floor. In case the cleaner is flipped upside down, use the floating handle to correct its orientation.CF-45-CL-Robotic-Cleaner-fig- (10)

Let it clean
The robotic cleaner shall run around the pool floor and vacuum the debris automatically the for max. 60 minutes. It will automatically reverse when it touches the wall. The cleaner will move to the pool wall automatically and stop running when it runs out of battery.

Retrieve the cleaner
To retrieve the robot, grasp the flipper and pull it out of the water and away from the pool. Power off the robot. Use the retrieving hook if needed.

BUZZER NOTECF-45-CL-Robotic-Cleaner-fig- (11)

MAINTENANCE & ADJUSTMENTS

CLEAN AFTER USE

  • Open all lock buckles, detach the top cover, and remove the filter screen.CF-45-CL-Robotic-Cleaner-fig- (12)
  • Rinse off all the dirt and debris with running water.CF-45-CL-Robotic-Cleaner-fig- (13)
  • Wipe the robotic cleaner with a clean cloth and let it air dry.

ADJUSTMENT OF RUNNING PATTERN

  • This robotic cleaner comes with 2 adjustable wheels. By modifying the combination of these 2 adjustable wheels, it will change the running pattern of the cleaner.CF-45-CL-Robotic-Cleaner-fig- (14)
  • To adjust the wheel, open the lock buckles and remove the top cover. Locate the 2 adjustable wheels. Detach the wheel by pushing the wheel stem catch. Select the correct combination and insert the wheel until the catch clicks.CF-45-CL-Robotic-Cleaner-fig- (15)
  • Combinations: :
    A – C: for most types of pool (factory setting)
    B – C: Smaller rebounding angle than A – C
    C – C: Minimum maneuvering (For rectangular or longer pool)
    A – B: For round poolsCF-45-CL-Robotic-Cleaner-fig- (16)

POOL WATER CONDITION
Remark: The pool water condition must be within the following parameters:

  • PH: 7.0-7.4
  • Temperature: 50°F -95°F (10°C – 35°C )
  • Salt: Max. 5,000 ppm
  • Chlorine: Max. 2 ppm

TROUBLESHOOTING

CF-45-CL-Robotic-Cleaner-fig- (17)

WARRANTY

  • This product is covered by a warranty for 24 months (only for the driving kit and control box kit) from the date of purchase. Consumable parts are beyond warranty which include Filter Tray/ Brush/ Wheels/Nozzles.
  • This warranty is voided if the product has been altered, misused, or has been repaired by unauthorized personnel.
  • The warranty extends only to manufacturing defects and does not cover any damage resulting from the mishandling of the product by the owner.
  • The order number or record must be presented for any claim or repair during the warranty period.

CF GROUP DEUTSCHLAND GMBH
BAHNHOFSTRASSE 68 73240 WENDLINGEN – GERMANY
INFO.DE@CF.GROUP
WWW.CF-GROUP/DEUTSCHLAND
+49 (7024) 4048 – 100

Documents / Resources

CF 45 CL Robotic Cleaner [pdf] Instruction Manual
45 CL Robotic Cleaner, 45 CL, Robotic Cleaner, Cleaner

References

Leave a comment

Your email address will not be published. Required fields are marked *