SEALEY HT08R 8W COB LED Rechargeable Head Torch With Auto Sensor User Guide

Avoid opening, disassembling, modifying, or servicing the battery pack.
Do not crush, puncture, short external contacts, or dispose of in fire or water.

Replace only with designated battery pack and dispose of used battery as per local regulations.
If electrolyte gets on the skin or eyes, rinse thoroughly and seek medical attention.

Operation

Remove the USB cover to reveal the USB charging point.

Insert the provided USB charging cable into the charging point.
Plug the cable into an appropriate power source for charging (approximately 3 hours).

Additional Features

Auto-sensor feature for easy on/off control by hand movement alongside the head torch.

Water-resistant with an IP65 rating.
Four modes: full, 30%, red, and flashing red for versatile use.

Inclination adjustment for directing light as needed.
Battery level indicator for monitoring charge status while charging.

Frequently Asked Questions

Q: How do I know when the battery is fully charged?

A: The product is equipped with a battery level indicator that will show when the battery is fully charged.

Q: Can I use a different type of battery with this head torch?

A: It is recommended to only use the designated 3.7V 1200mAh Lithium-Polymer battery for this product to ensure proper functionality and safety.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

SAFETY

GENERAL

Ensure the lamp is fully charged before initial use.
DO NOT turn the lamp on when it is being charged.
DO NOT shine directly into your, another person’s, or an animal’s eyes.
DO NOT allow children to use the lamp.
DO NOT handle or move the lamp whilst it is being charged.
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
DO NOT leave a battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.
WARNING! To reduce the risk of burns or fire:

DO NOT attempt to open, disassemble, modify, or service the battery pack.
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
DO NOT expose to temperatures above 60°C (140°F).

Replace only with the battery pack designated for this product.
Recycle or dispose of used batteries as stipulated by local regulations.
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.
It must be understood that common sense and caution are factors which must be applied by the operator.

INTRODUCTION

Powered by a 3.7V lithium rechargeable battery. Auto-sensor means once active, you can simply move your hand alongside the head torch to turn it on and off. IP65 Water resistant.

The four modes include: full, 30%, red, and flashing red. Inclination can be adjusted to better direct the light. 1200mAh battery with level indicator while charging.

SPECIFICATION

Model No:…………………………..HT08R,HT08R, HT08RG
Battery:…………………….3.7V 1200mAh Lithium-Polymer

Charging Time:…………………………………………………..3hr
LED Type:…………………………………………………8W COB
Lumen Output:……………………………………………… 500lm

Nett Weight:………………………………………………….. 0.1kg
Operating Time:………………………..(High/Low): 2.5hr/4hr

OPERATION

Remove the USB cover to reveal the USB charging point, where the provided USB charging cable can be inserted fig.1.

Plug in the cable to an appropriate power source. Charging will take approximately 3hr
Four lights illuminate when charging. These indicate the amount of charge in the battery. 1 = low charge and 4 = fully charged.
When charged remove the USB cable and replace the USB cover

To switch it on press the on/mode change/off button full power white light, press again to change the mode to reduced power white light, and press again for a constant red light a fourth time for a flashing red light once more to turn it off.
To activate by hand movement, there is a second switch hold down (approx 3 sec.) on/mode change/off button until the button turns full power light on. It can now be operated by passing a hand in front of the sensor. Press the button again to switch off.
The head torch can be tilted forward up to 53° from vertical in four stages.

This is achieved by a cog system molded to the rear of the unit.

MAINTENANCE

Keep the torch clean by wiping it with a damp cloth.
Store the torch in a dry childproof area.

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling center, and disposed of in a manner that is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE).
When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

BATTERY REMOVAL

Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd is required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications, and parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.

Warranty

Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500
sales@sealey.co.uk

www.sealey.co.uk
HTR08R HT08RG HT08RR Issue 2 09/07/24

Documents / Resources

SEALEY HT08R 8W COB LED Rechargeable Head Torch With Auto Sensor [pdf] User Guide
HT08R 8W COB LED Rechargeable Head Torch With Auto Sensor, HT08R, 8W COB LED Rechargeable Head Torch With Auto Sensor, LED Rechargeable Head Torch With Auto Sensor, Head Torch With Auto Sensor, With Auto Sensor, Auto Sensor, Sensor

References

User Manual

SEALEY HT08R 8W COB LED Rechargeable Head Torch With Auto Sensor

Product Information

Product Usage Instructions