8BitDo SN30 2.4G Nt Wireless Controller User Manual
SN30 2.4g – Instruction
Super Nintendo Entertainment System & Super Family Computer & Analogue Super Nt
1. Plug the receiver to your chosen device, blue LED blinks once per cycle
2. Press start button on the controller to pair
3. Blue LEDs on both the controller and receiver become solid when connection is successful
Battery
| Controller Status | LED Indicator |
| Low battery | Red LED blinks |
| Battery charging | Red LED stays solid |
| Battery fully charged | Red LED turns off |
- Built-in180 mAh Li-on with18 hours of playtime
- Rechargeable via USB cable with 1- 2 hour charging time
- Controller turns off in 1 minute with no connection and 15 minutes with connection but no use
Retrieve a lost connection or connect to a new receiver
1. Turn on the controller then press and hold select button for 3 seconds. Blue LED starts to rapidly blink
2. Move the controller close to the receiver. Blue LED becomes solid when connection is successful
Support
Please visit support.8bitdo.com for further information & additional support
FAQ – Frequently Asked Questions
SN30 2.4G NT works with original SNES / SFC console.
SN30 2.4G works with NES / SFC / SNES Classic console.
Yes, there is a 2.4g receiver for SNES that comes with it.
Yes, you can. One receiver for one controller port. One receiver for one controller.
Yes, you can use it on Windows 10 and Switch wired via USB cable.
No, it does not. It only works with the 2.4g receiver which comes with it.
We suggest you charge it via a phone power adapter and original USB cable.
The controller uses 180mAh rechargeable battery with 1-2 hour charging time. The battery can last up to 18 hours when fully charged.
Download
8BitDo SN30 2.4G Nt Wireless Controller User Manual – [ Download PDF ]
