smartwares SH4-99578 Wireless Switch Set

Specifications

Remote control (SH4-90151)

• Battery: 3VDC, type CR 2032 (incl.)
• Radio Frequency: 433.92Mhz
• Maximum output: 0dBm
• Maximum range: 30m

EU plug (SH4-99578)
Maximum power: 2300 W
AC input Voltage: 230V ~ 50Hz

CE
smartwares Europe
Jules Verneweg 87 5015 BH Tilburg The Netherlands www.smartwares.eu

PREPARATION BEFORE USE

Insert battery

• Open the battery lid at the back of the remote (1) by turning it counter clockwise.
• Insert the battery with the negative polarity downward.
  To check if the battery is inserted correctly, briefly press a button on the remote. If the LED flashes, then the battery is inserted successful.
• Insert the receiver into the wall outlet.
  NOTE: The socket-outlet must be installed close to the equipment and must be easily accessible.

PAIRING THE REMOTE TO THE RECEIVER

• Press the button on the receiver (2) for 3 seconds. When the LED starts to blink, the receiver is in pairing mode.
• Press any of the ON buttons on the remote. If the LED stops blinking and is constantly lit, the pairing was successful.

OPERATING RECEIVERS

• Press the ”ON” button on the remote control to turn on the receiver.
• Press the “OFF” button on the remote control to turn off the receiver.
• Press the ”ON” button beneath ALL (on the remote control) to turn on all paired devices at the same time.
• Press the ”OFF” button beneath ALL (on the remote control) to turn off all paired devices at the same time.

Disconnecting a remote

• Press and hold the button on the receiver for 3 seconds (3) and then release it. During this operation the LED starts to blink. Your receiver is now switched into the pairing mode. Attention: the LED should blink only after releasing the button. If the LED starts to blink while holding the button, there will be no pairing.
• Perform one of the following steps:
• Press an ”OFF” button on the row on the remote you wish to disconnect from a receiver. During this operation the LED on the receiver blinks quickly and then turns off.
• Press the ”OFF” button next to ALL (on the remote) to disconnect all links. During this operation the LED on the receiver turns off.
• To remove all pairing memories on the receiver:
  • Press and hold the button for more than 6 seconds (3).

    

Documents / Resources

smartwares SH4-99578 Wireless Switch Set [pdf] Instruction Manual SH4-99578 Wireless Switch Set, SH4-99578, Wireless Switch Set, Switch Set

References

• User Manual