SLV-LOGO

SLV 1007672 One Cube Up Down LED

SLV-1007672-One-Cube-Up-Down-LED-PRODUCT

  • SLV-1007672-One-Cube-Up-Down-LED-FIG-4The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
  • The light source is only exchangeable by a professional. The separate control unit is only exchangeable by a professional.SLV-1007672-One-Cube-Up-Down-LED-FIG-5
  • Technical Details are subject to change

Operating Manual PART B

SLV-1007672-One-Cube-Up-Down-LED-FIG-1

Tools RequiredSLV-1007672-One-Cube-Up-Down-LED-FIG-2

Pendant Light

SLV-1007672-One-Cube-Up-Down-LED-FIG-3

  • Read the manual carefully and keep it for further use!
  • Safety advise for installation and operation.
  • Disregarding may lead to danger of life, burning or fire!
  • Any work on the electrical connection only by the electrician.
  • Do not alter or modify the product.
  • Do not fasten anything on the product.
  • Do not cover the product.
  • Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
  • Take measures that children are not harmed by the product.
  • Do not stare into the active light source.
  • Additional safety bits of advice =SLV-1007672-One-Cube-Up-Down-LED-FIG-6

Use as directed

  • Safety class I (1) SLV-1007672-One-Cube-Up-Down-LED-FIG-7Connection with protective conductor.
  • Operate only firmly fixed on an even surface.
  • Operate only on normal or not inflammable surfaces.
  • Operate only in dry indoor areas.
  • Do not strain mechanically or expose to strong dirt contamination.
  • Admissible ambient temperature(ta): -20°C …35°C.

Light Source
The light source of this luminaire may only be replaced by the manufacturer, an authorized service technician or a comparable qualified person. This product contains light sources of the energy efficiency class E.

SLV-1007672-One-Cube-Up-Down-LED-FIG-6Care / Storage

  • Disconnect the product from the mains and let it cool down.
  • Clean external surfaces regularly with a slightly moistened (water) cloth.
  • Store dry and clean.

Installation

  • Switch off mains / fixed connection cable!
  • Use only described accessories.
  • Use only suitable fastening materials.
  • Only suited for ceiling surface mounting.
  • Install as shown in the figure.
  • Adjust the pendant length of the wires with the wire fixer.
  • Adapting the pendant cable: Loosen strain relief (A).
  • Push the pendant cable into the canopy.
  • Secure the strain relief. The pendant cable may not be strained.
  • Suitable Dimmer: DALI dimmer / light control. Note the manufacturer`s instructions.

Electrical connection

  • Equip flexible wire ends with suitable wire ferrules!
  • Live conductor
  • Terminal L
  • Neutral conductor
  • Terminal N
  • Protective conductor
  • Earth terminal
  • Dali control wires
  • Terminals DA
  • Check secure fixation and proper function!

Documents / Resources

SLV 1007672 One Cube Up Down LED [pdf] Instruction Manual
1007672 One Cube Up Down LED, 1007672, One Cube Up Down LED, Cube Up Down LED, Up Down LED, Down LED, LED

References

Leave a comment

Your email address will not be published. Required fields are marked *