FRIHULT Ceiling Lamp Assembly Instructions

Important Safety Information

⚠️ IMPORTANT! Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.

Installation in Bathrooms

? The installation shall be carried out by an authorized electrical contractor. The luminaire must be permanently installed in the electric system and placed in the correct zone. Different materials require different types of fittings. Always choose screws and plugs that are specially suited to the material.

Assembly Instructions

Step 1: Prepare Mounting Plate

Secure the mounting plate to the ceiling electrical box using two screws (2x). Ensure the plate is oriented correctly. The inset shows a close-up of a screw and a screwdriver bit.

Step 2: Wire Connection Preparation

Connect the wires from the ceiling to the lamp's internal wiring. Ensure power is OFF before proceeding. The diagram shows a screwdriver inserting a wire into a terminal block.

Step 3: Route Wires

Thread the ceiling wires through the opening in the mounting plate.

Step 4: Attach Lamp Body

Attach the main lamp body to the mounting plate. Align the lamp body and twist clockwise ? to secure it. Ensure the electrical connection is made.

Step 5: Mount to Ceiling

Mount the lamp to the ceiling. Use appropriate screws and wall plugs for your ceiling material. (Note: Screws and plugs for mounting to the ceiling are not included, as they depend on the ceiling material.) The inset shows a screw being inserted and a crossed-out image of an unsuitable screw.

Step 6: Connect Electrical Wires

Connect the wires to the terminal block. Connect the live wire (L) to the terminal marked 'L' and the neutral wire (N) to the terminal marked 'N'. Ensure connections are secure. Refer to the diagram showing L and N terminals.

Step 7: Secure Lamp Body

Secure the lamp body to the mounting plate by pushing upwards ⬆️ until it clicks into place.

Step 8: Attach Glass Shade

Attach the glass shade. Secure the glass shade using two screws (2x).

Step 9: Secure Glass Shade

Twist the glass shade clockwise ? to fully secure it to the lamp body.

Step 10: Install Light Bulb

Install a light bulb (not included). Screw the bulb into the socket, turning clockwise ?.

Step 11: Final Assembly

Final assembly complete. Ensure all parts are securely attached.