SKYROVER KNIGHTFORCE US858922 Radio Control Helicopter Instruction Manual

KNIGHTFORCE US858922 Radio Control Helicopter

Specifications

  • Model: SKY ROVER KNIGHTFORCE US858922
  • Functions: Rise, Fall, Turn Left, Turn Right, Forward,
    Backward, Stop
  • Power Supply: 3 AAA (LR03) alkaline batteries for remote
    controller (Batteries sold separately)

Product Usage Instructions

Assembly Instructions

Follow the steps below to assemble your SKY ROVER KNIGHTFORCE
US858922:

  1. Locate the Throttle Lever (13), Speed mode (14), Power switch
    (15), Steering Lever (16), Power light (17), and Left/Right Trimmer
    (18) components as shown in Fig.B & C.
  2. Install batteries in the remote controller by removing the
    locking screw on the back of the controller and opening the battery
    cover (Fig.18).
  3. Insert 3 AAA (LR03) batteries into the remote controller in the
    correct polarity (Fig.19).
  4. Close the battery cover (Fig.20) and reinstall the locking
    screw to secure the battery door.

Battery Safety Information

Ensure the following for battery safety:

  • Use 3 x 1.5 V (AAA) batteries.
  • Follow correct polarity when inserting batteries.

FAQ

Q: Where can I purchase replacement batteries for the remote
controller?

A: Replacement batteries can be purchased at most electronics or
convenience stores. Ensure to use 3 AAA (LR03) alkaline
batteries.

Q: What should I do if the remote controller is not functioning
properly?

A: Check the battery installation and ensure they are placed
correctly with the right polarity. If the issue persists, contact
customer service for further assistance.

“`

4*;&NN

SKY ROVER KNIGHTFORCE US858922
· Keep these instructions for future reference as they contain important information. · Conservez ces instructions pour référence future car elles contiennent des
informations importantes. · Guarde estas instrucciones para consultarlas en el futuro como referencia, ya que contienen información importante. 22..44 GGHHzz
HVIN:US858922-31
8+ AGES·ÂGE·EDADES

%

19

20

13

16

17 14

15

18

Contents and overview
Functions and Specifications : Full function : Rise, Fall, Turn Left, Turn Right, Forward, Backward, Stop. Power supply : 3 AAA (LR03) alkaline batteries for remote controller
( Batteries sold separately) Components : (Fig.B & C) 13.Throttle Lever 14.Speed mode 15.Power switch(OFF-ON) 16.Steering Lever 17.Power light 18.Left/Right Trimmer
Assembly instructions
Remote Control Battery Installation : (Fig.D)
Locate the locking screw on the back of the controller and remove it from the battery cover(Fig.18) , insert 3 AAA (LR03) batteries in correct polarity(Fig.19), and then close the battery cover(Fig.20). Reinstall locking screw to secure the battery door.
©2025 ALPHA All rights reserved. MADE IN CHINA

Battery safety information :
Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e.alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals. Rechargeable batteries are to be removed from the toy before being charged Batteries are only to becharged by adults or by children at least 8 years old.
Requires 3 x 1.5 V (AAA) batteries.
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life it should not be disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.
ALPHA GROUP CO., LTD. Alpha Animation Industrial Area, Jinhong Road East & Fengxiang Road North, Chenghai District, Shantou, Guangdong, P.R.China(515800) AULDEY TOYS OF NORTH AMERICA. LLC. 13048 Valley Blvd, Fontana, CA92335, USA Tel: 1-800-328-7363 customerservice@alphagroup-us.com www.alphatoys.com

FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. CAN ICES-3(B)/NMB-3(B)
portable device statements The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Consignes de sécurité au sujet de piles :
µLes piles sont de petits objets. µLe remplacement des piles doit être réalisé par un adulte. µRespecter le diagramme de polarité (+/-) dans le compartiment des piles. µRetirer rapidement les piles usées du jouet. µÉliminer les piles usagées selon les réglementations en vigueur. µRetirer les piles avant un rangement prolongé. µUtiliser uniquement des piles de types identiques ou équivalents, tel que recommandé. µNE PAS brûler les piles usées. µNE PAS jeter les piles au feu, car elles pourraient exploser ou couler. µNE PAS utiliser conjointement des piles usagées et des piles neuves ou différents types de piles (par ex. : alcaline / standard). µNE PAS utiliser de piles rechargeables. µNE PAS recharger les piles non rechargeables. µNE PAS court-circuiter les bornes d’alimentation. µLes piles rechargeables doivent être rechargées sous la surveillance d’un adulte. µLes batteries ne doivent être chargées que par des adultes ou par des enfants âgés d’au moins 8 ans.
·Fonctionne avec 3 piles (AAA) 1,5 V. Les piles ou les batteries doivent être correctement recyclées ou éliminées. Lorsque ce produit arrive en fin de vie, il ne doit pas être jeté avec le reste des déchets ménagers. Conformément à la directive sur les Déchets des équipements électriques et électroniques (DEEE), il doit être collecté séparément afin d’être éliminé selon les meilleures techniques de récupération et de recyclage disponibles. Cette démarche réduit les risques de pollution du sol et des eaux, et permet ainsi de minimiser l’impact de toute substance nocive sur la santé et sur l’environnement. Cela diminue également la quantité de ressources nécessaires à la fabrication de nouveaux produits, et évite la saturation des sites d’enfouissement. Veuillez apporter votre contribution en ne jetant pas ce produit avec les déchets de votre commune. Le symbole de la « poubelle sur roues » signifie que ce produit doit faire l’objet d’une collecte respectant la directive sur les Déchets des équipements électriques et électroniques (DEEE). Vous pouvez également retourner les produits en fin de vie à votre détaillant lors de l’achat d’un produit similaire neuf. Pour plus d’informations, contactez votre commune.

FR
Table des matières et aperçu
Fonctions et caractéristiques : Fonctions complètes : monter, descendre, tourner à gauche, tourner à droite,
avancer, reculer, arrêter. Alimentation électrique : 3 piles alcalines AAA (LR03) pour la télécommande
(piles vendues séparément) Composants : (fig. B et C) 13.Levier d’accélération 14.Mode de vitesse 15.Interrupteur (ARRÊT-A-B) 16.Levier de direction 17.Témoin d’alimentation 18.Compensateur gauche/droite
DDiirreeccttiivveessddee mmoonnttaaggee
Installation des piles de la télécommande : (fig. D) Localiser la vis de verrouillage située derrière la commande et la retirer du couvercle du compartiment à piles (fig. 18); insérer 3 piles AAA (LR03) en respectant la polarité (fig. 19), puis refermer le compartiment à piles (fig. 20). Réinstaller les vis de verrouillage pour fixer le couvercle du compartiment à piles. ©2025 ALPHA Tous droits réservés. FABRIQUÉ EN CHINE

Remarque :
ce matériel a été testé et déclaré conforme aux limites pour un appareil numérique de classe B, en vertu de la Partie 15 des Règles FCC. Ces limites ont pour objet d’offrir une protection raisonnable contre le brouillage préjudiciable dans une installation résidentielle. Cet appareil produit, utilise et émet de l’énergie des fréquences radio. S’il n’est pas installé et utilisé conformément à ces consignes, il peut occasionner des interférences nuisibles aux communications radio. Cependant, il n’y a aucune garantie qu’il ne se produira pas d’interférences dans une installation en particulier. Si ce matériel provoque un brouillage préjudiciable à la réception radio ou de télévision, ce qui peut être établi en coupant et en rallumant l’appareil, il est conseillé d’essayer de corriger ce brouillage par l’une ou plusieurs des mesures suivantes : – Réorienter ou déplacer l’antenne réceptrice. – Augmenter la distance entre l’appareil et le récepteur. – Brancher l’appareil dans un circuit différent de celui du récepteur. – Obtenir l’aide du revendeur ou d’un technicien de radio/TV compétent. Ce dispositif est conforme à la Partie 15 des Règles FCC. Le fonctionnement est soumis aux deux conditions suivantes :
1.cet appareil ne peut causer d’interférences nuisibles, et 2.cet appareil doit accepter toute interférence reçue, notamment les interférences susceptibles d’occasionner un fonctionnement indésirable. Tout changement ou toute modification n’ayant pas été expressément approuvé(e) par la partie responsable de la conformité pourrait annuler le droit de l’utilisateur à utiliser ce dispositif. Le présentappareilestconforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitationestautorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d’encompromettre le fonctionnement. CAN ICES-3(B)/NMB-3(B)
Déclarations d’appareils portables L’appareil a été évalué pour répondre aux exigences générales en matière d’exposition aux RF. L’appareil peut être utilisé en condition d’exposition portable sans restriction.

64

Documents / Resources

SKYROVER KNIGHTFORCE US858922 Radio Control Helicopter [pdf] Instruction Manual
US858922, 2AIRP-858932, 2AIRP858932, KNIGHTFORCE US858922 Radio Control Helicopter, KNIGHTFORCE US858922, Radio Control Helicopter, Control Helicopter, Helicopter

References

Leave a comment

Your email address will not be published. Required fields are marked *