Hub / Gateway
Quick start Guide
Hub, Gateway
ATTENTION
Please setup and register this device FIRST!
In order to receive alerts, the Skyhawk Hub must be used in conjunction with a Skyhawk Sensor (sold separately) and the Skyhawk CE smartphone app.
See the specific Skyhawk Sensor user’s manual for additional information on connecting your devices.
Need to download the Skyhawk CE App?
Device Overview
Device Status Lights
| Powering Up |  |
| Powering Down |  |
| RF Event Trigger |  |
| Device Reset |  |
| Firmware update |  |
| *Success Indicator, Solid LED |  |
| *Failure Indicator, Solid LED |  |
While unit is ON and not being triggered the status LED will flash every 5 seconds:
| Last transmission was successful |  |
| Last transmission failed |  |
| Unit currently paused |  |
Activate Hub
Scan the unique QR code located on the back of the device and follow all in-app instructions to finish activating your Hub.
NOTE: QR code and serial number can also be found on the original packaging.
Start-Up Operation
- Power ON the Hub by pressing and holding the function button; release when the GREEN status LED starts blinking.
- Upon successful completion of the power ON process an alert will be sent to the Skyhawk CE application.
Shutdown Operation
- Power OFF the Hub by pressing and holding the function button; release when the RED status LED starts blinking.
- Upon successful completion of the power OFF process an alert will be sent to the Skyhawk CE application.
Resetting Hub
(Factory Default Setting)
| 1 | Press & Hold Function Button |  |
| 2 | Keep Holding Function Button |  Press and hold button until LED sequence changes to rapid blinking red |
| 3 | Release Function Button |  |
| 4 | Startup Operation Begins |  |
Battery Replacement
IMPORTANT: Always replace batteries with 3 new and identical name-brand AA lithium batteries.
| 1 | Unscrew/Open Hub Case |  |
| 2 | Remove Batteries |  |
| 3 | Insert New Batteries (Following +/- symbols) |
 |
| 4 | Close Case > Startup Sequence Begins |  |
(Refer to hardware manual for detailed instructions)
Product Support & Manuals
For product support and to download detailed user and product manuals: support.sky-hawk.com
FCC Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
App Store and the Apple logo are trademarks of Apple Inc.
Google Play and the Google Play logo are trademarks of Google LLC.
Skyhawk™, No Wi-Fi. No Power. No Problem.™, Skyhawk CE™ and Skyhawk Logo are trademarks of
PICA Product Development, LLC, dba Skyhawk. ©2021 All rights reserved.
Rev A1 – 7/21
Documents / Resources
 |
Skyhawk Hub, Gateway [pdf] User Guide Hub Gateway, Hub, Gateway |
