User Manual
(433mhz door sensor )
Specifications
| RF | 433MHz |
| Working voltage | DC12V |
| Battery model | 2*23A |
| Working current | 0.18a |
| Stand-by current | 3ua |
| Wireless transmission distance | ≤ 80m |
| Installation gap | <10mm |
| Working temperature | – 10℃~40℃ |
| Material | ABS |
| Dimension | Transmitter: 765.5*25*14.5mm |
Product Introduction
The device’s weight is less than 1 kg.
Install batteries
- Remove the cover of the sensor.
- Insert batteries into the battery compartment based on identifiers of positive and negative poles.
- Close the cover.
Install the device
- Take out the insulation sheet, Paste 3m adhesive to the sensor and Tear off the protective film of the 3M adhesive.
- Try to align the marked line on the magnet with that on the transmitter during installation.
- Install them in the opening and closing areas separately.
Application
Note:
- Do not install outside the door/window.
- Do not install in an unstable position or in a place exposed to rain or moisture.
- Do not install near wiring or magnetic object.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used
in portable exposure conditions without restriction.
Documents / Resources
 |
Shenzhen Daping Computer DP-07D 433mhz Door Sensor [pdf] User Manual DP-07D, DP07D, 2AYOK-DP-07D, 2AYOKDP07D, DP-07D 433mhz Door Sensor, 433mhz Door Sensor, Door Sensor, Sensor |
