QUICK START GUIDE
[ Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit. ]
This article contains the Quick Start Guide for the NV100 Series Shark Navigator® Light. This supports the following product SKUs NV100, NV100C, NV105, and NV106.
WHAT’S INSIDE
A. Handle
B. Wand
C. Hose
D. Dust Cup
E. Hose Connector
F. Vacuum Body
G. Accessory Holder
H. Floor Nozzle
I. Duster Crevice Tool
J. Upholstery Tool
ASSEMBLY
TIPS:
For quick cord access, rotate upper hook down and remove cord.
EMPTYING THE DUST CUP
Dust cup Release Button
FILTER MAINTENANCE:
- Rinse pre-motor filters every month, and the HEPA filter once a year. Rinse filters only with water and air-dry completely before reinstalling.
- See enclosed Owner’s Guide for more information on how to clean and replace the filters.
CHECKING FOR BLOCKAGES
Dust Cup Air Duct:
Remove and empty dust cup. Check the airway behind dust cup and clear any blockages.
Hose Intake Opening:
Pull down the hose intake door to remove. Turn the knob on the hose intake to the center, then detach.
Clear any obstructions. Reattach the hose intake, then turn the knob to the left to lock. Reinstall the door, clicking it into place.
Hose:
Disconnect both ends of the hose by gently pressing the tabs together and pulling the hose out of the connectors. Remove any obstructions, then reattach.
2 WAYS TO CLEAN
UPRIGHT
Carpet
To use the brushroll to clean carpets, press the Brushroll button and tilt the handle back. The brushroll indicator light will turn green.
Bare Floors
To clean bare floors or to use the hose, turn off the Brushroll button. The brushroll indicator light will go out.
Indicator Light
ABOVE-FLOOR CLEANING
For questions or to register your product, visit us online at sharkclean.com
©2019 SharkNinja Operating LLC.
Download
Shark NV100 Series Navigator Light:
Quick Start Guide – [Download PDF]
Owner’s Guide – [Download PDF]
