SHAPE Window Well Covers Instruction Manual

Spring Clip Hardware
Installation Instructions

What You Need

Tension Spring Clips
3/16″ Bolts
3/16″ Cap Nuts

  VIDEO INSTRUCTIONS

Installation

1. Place the window well cover over the window well and push it tight against the exterior of the house. (FIGURE A)

FIGURE A

2. Center the cover on your well and mark the locations where the clips will attach. (FIGURE B)

FIGURE B

3. Remove the cover from your well and drill a 3/16″ hole at each marked location. (FIGURE C)

FIGURE C

4. Mount the clips to your cover using the provided cap nuts and bolts provided and tighten the screw until you’ve reached your desired tension. (FIGURE D)

FIGURE D

5. Snap the window well cover onto the rim of the window well. (FIGURE E)

FIGURE E

Cleaning Instructions

Clean your window well cover with a mild solution detergent and water. Use of harsh chemicals or solvents may damage plastic and void warranty.

For warranty information, visit our website

www.shapeproducts.com | 5205 Freitag Drive Menomonie, WI 54751 | Phone: (715) 232-0495 | Email: info@shapeproducts.com