SEWOSY SHOKV1 Alarm Button Green with LED Indication and Alarm Signal Instruction Manual
SEWOSY SHOKV1 Alarm Button Green with LED Indication and Alarm Signal

REFERENCES

References Designation
SHOKV1 Manual call point 1 contact
SHOKV2 Manual call point 2 contacts
SHOKV3 Manual call point 2 contacts and Buzzer / LED
SHOKV4 Manual call point 2 contacts with cover opening detection and Buzzer / LED

TECHNICAL SPECIFICATIONS

General specifications of the manual call point

  • Operating voltage : 12-24V DC (+10%)
  • Consumption : 12V DC – max. 45 mA / 24V DC – max. 62 mA
  • Switching rate (C/NO/NC) : 250V AC – 5 A / 30V DC – 4 A
  • IP rating : IP 40 uniquement only for indoor use
  • Conductor’s cross section : max 1 mm²
  • Operating temperature : 0 / +50°C
  • Weight : 0,17 kg

KIT

Reset Key x2
Kit Content
SHOK_K
Protection cover x1
Kit Content
SHOK_C (SHOKV1 – V2 – V3) SHOK_P
SHOK_CA (SHOKV4)
Cover screw for surface mounting x1
Kit Content
K30x25
Cover screw and nut for semi-flush mounting x1
Kit Content
M3x16 M3
Green plastic seal x1
Kit Content
SHOK_P

MOUNTING

Semi-flush mounting

Semi flush mounting
Semi flush mounting
Semi flush mounting

Surface mounting

Surface mounting

Surface mounting possible with standard 60 mm outlet box

Surface mounting possible with standard 60 mm outlet box

Mounting of the cover

Surface mounted
Mounting of the cover
Semi-flush mounted
Mounting of the cover

CABLE DUCT ENTRY

Cable Duct Entry

MANUAL CALL POINT RESET

Front reset
Call Point Reset
OR
Reset below
Call Point Reset

RESET KEY SLOTS

Reset Key Slots
Reset Key Slots

CONNECTION

Connection

Connecting whilst switched on
Connection
Connecting whilst disarmed (factory setting)
Connection

Warning Icon The electronic board is fixed to the manual call point. Do not remove it!

JUMPER CONFIGURATIONS

SHOKV3

Jumper Configrations

Jumper STATE OF THE BUZZER
Jumper Configrations When triggered, the buzzer sounds continuously (ON – 70 dB)
Jumper Configrations Buzzer disabled (OFF)

STATE OF THE LEDs

  • Call point switched on: Green
  • Call point disarmed: Red

SHOKV4

Jumper Configrations

Jumper STATE OF THE BUZZER
Jumper Configrations When the cover is opened, the buzzer sounds discontinuously (ON – 70 dB)
When triggered, the buzzer sounds continuously (ON – 70 dB)
Jumper Configrations When the cover is opened, the buzzer is disabled (OFF)
When triggered, the buzzer sounds continuously (ON – 70 dB)
Jumper Configrations Buzzer disabled (OFF)

STATE OF THE LEDs

  • Call point switched on: Green
  • Call point disarmed: Red
  • Cover open: Flashing: white

DIMENSIONS

Diminsions
Diminsions

SHOK Logo

Documents / Resources

SEWOSY SHOKV1 Alarm Button Green with LED Indication and Alarm Signal [pdf] Instruction Manual
SHOKV1 Alarm Button Green with LED Indication and Alarm Signal, SHOKV1, Alarm Button Green with LED Indication and Alarm Signal, LED Indication and Alarm Signal, Alarm Signal

References

Leave a comment

Your email address will not be published. Required fields are marked *