SEPLOS BatteryMonitor Software Installation Guide

SEPLOS BatteryMonitor Software

INSTALLATION INSTRUCTIONS

1. Unzip the BatteryMonitor file
   
2. Open the folder – Find the application file – Double click the application to run the software.
   
3. Click ’import protocol’ – Find the open the ‘Agreement’ file – choose the corresponding agreement (The one end with ‘EN’ means English version agreement) – Click ‘open’ – Click ‘confirm’
   
   
4. Choose the port number ( the port number of USB to RS485 adapter can be identified automatically) – Choose baud rate 19200 – Click ‘Connect’.
   
   If successfully connected, the battery information will be displayed as the following screenshot.
   
5. Login
   Login account: admin/Password: admin
   
6. Upload parameter (to upload parameter to the software)
   Load parameter (to load parameter settings from software)
   Note: When running the software for the first time, need upload parameter, then load parameters.
   
7. Modify parameter
   • Click ‘upload parameter’
   • Modify the parameter or turn on/off the functions
   • Click ‘Set all’ to save the modification
     
8. Load parameter
   Click ‘load parameter’ – Click ‘open’
   
   
9. Communication protocol.
   

   Protocol Type	Compatible Inverter
   PN-GDLT	Pylontech/Goodwe/TBB/ Luxpower/DEYE
   GRWT	Growatt SPF/SPH
   VCTR	Victron
   SMA-SF	SMA/SOFAR
   GINL	Solis
   Studer	Studer

   Click the pull-up menu of ‘CAN’ – and choose the corresponding protocols according to inverters – Click ‘Close’ refresh the software – The corresponding inverter manufacturer information will be displayed.
   
   
   

10. Software interface
    
    Interface specifications
    

    Item	Introduction	Remark
    Max voltage	The maximum cell voltage value
    Min voltage	The minimum cell voltage value
    Voltage difference	The voltage difference between highest cell and lowest cell
    Battery voltage	Battery pack voltage
    Current	Charging/discharging current (-*)
    Remaining capacity	The remaining capacity	configurable
    Total capacity	The real capacity of battery pack
    SOC	State of charge
    Rated capacity	Rated capacity	configurable
    Battery cycles	80% DOD for one cycle
    SOH	State of health	Green: ON Grey: OFF
    BUS voltage	BUS bar voltage
    Discharge switch	Discharge indicator
    Charging switch	Charge indicator
    Current limit switch	Current limit indicator
    Temperature control switch	Temperature control indicator
    Warn and protect	Battery status
    Battery temp1	Temperature value of cell 1
    Battery temp2	Temperature value of cell 2
    Battery temp3	Temperature value of cell 3
    Battery temp4	Temperature value of cell 4
    Ambient temp	Ambient temperature
    Power temp	MOSFET temperature

11. Parallel connection
    Maximum 16 packs connected in parallel. Choose the corresponding pack number according to DIP address settings with the software.
    The paralleled pack quantity is will displayed.
    Select the cycle fresh, all the paralleled packs’ information will be displayed in turn.
    And click multiple, all the packs’ details is displayed in one page.
    
    

Customer Support

https://manuals.plus/m/9d20f23cb517c43aafa06e743541cdd2acccad00de5915fa0bebc9c61e1ce3eb

www.seplos.com