Scupper Self Bailing Scupper Large Clear
Instruction Manual

INSTALLATION INSTRUCTIONS

Scupper Self Bailing Scupper Large Clear

1. Mount gasket and scupper over existing drainage hole using silicone around back of gasket.
2. Drill screw holes using 5/32″ drill bit.
3. Screw scupper and gasket into place using #8 x 1″ or #8 x 3/4″ Oval head screws.

Note:

• Gasket hole must be on bottom
• Scupper drain hole must face bottom of hull (down, as shown in photo)

Not liable for any improper installations. All boat repairs/modifications should always be performed by a licensed and insured professional.

Documents / Resources

SEACHOICE Scupper Self Bailing Scupper Large Clear [pdf] Instruction Manual Scupper Self Bailing Scupper Large Clear, Scupper, Self Bailing Scupper Large Clear, Scupper Large Clear

References

• User Manual