SpaceLogic KNX IP Interface DIN Rail
MTN6502-0105
MTN6500-0103 SpaceLogic KNX IP Router DIN Rail
https://go2se.com/ref=MTN6502-0105
SpaceLogic KNX IP Router DIN Rail
About this document
You can find all the information required for safe installation in this document.
More detailed product information is available on the Internet -> See QR code.
For your safety
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
Safe electrical installation must be carried out only by skilled professionals. Skilled professionals must prove profound knowledge in the following areas:
- Connecting to installation networks
- Connecting several electrical devices
- Laying electric cables
- Connecting and establishing KNX networks
- Connecting and establishing LAN networks
- Safety standards, local wiring rules and regulations
Failure to follow these instructions will result in death or serious injury.
Getting to know the device
The SpaceLogik KNX IP Router enables the forwarding of KNX telegrams between different lines via a LAN (IP) as a fast backbone. The device also be used as a programming interface between a PC and the KNX bus.
The device supports KNX Security and long frames.
Connections and operating elements
A Ethernet/LAN Connector
B IP LED (multicolor)
C Mode LED (multicolor)
D KNX LED (multicolor)
E Button: Pass GA (Forwarding of group addressed telegrams)
F Button: Pass IA (Forwarding of individually addressed telegrams)
G Programming LED (red)
H Button for programming mode
I KNX bus connector
J Release lever for disassembly
K Cable cover
Installation and connection
A Installing
B Removing
WARNING
Risk of death from electric shock. The device can be damaged.
Safety clearance must be guaranteed in accordance with IEC 60664-1.
There must be at least 4 mm between the individual cores of the 230V supply cable and the KNX line A.
WARNING
Risk of death from electric shock.
Only install devices with at least basic insulation next to the device.
Failure to observe this instruction can result in death or serious injury.
Note
The installation of communication cabeling for information technology must be guaranteed in accordance with DIN EN 50174.
Failure to observe these instructions can result in damage of devices or interfere the communication.
Technical data
| Power supply: | via KNX bus, < 20 mA |
| Connection | |
| LAN: | RJ45 connector |
| KNX: | Bus connecting terminal |
| Dimensions (LxWxD): | 100x18x66 mm |
| Device width: | 1 module = 18 mm |
Dispose of the device separately from household waste at an official collection point. Professional recycling protects people and the environment against potential negative effects.
Schneider Electric Industries SAS
If you have technical questions, please contact the Customer Care Centre in your country.
schneider-electric.com/contact
Documents / Resources
 |
Schneider Electric MTN6502-0105 SpaceLogic KNX IP Interface DIN Rail [pdf] Instructions MTN6502-0105, SpaceLogic KNX IP Interface DIN Rail, MTN6502-0105 SpaceLogic KNX IP Interface DIN Rail, KNX IP Interface DIN Rail, IP Interface DIN Rail, Interface DIN Rail, DIN Rail, Rail |
 |
Schneider Electric MTN6502-0105 SpaceLogic KNX IP Interface DIN Rail [pdf] Instruction Manual MTN6502-0105 SpaceLogic KNX IP Interface DIN Rail, MTN6502-0105, SpaceLogic KNX IP Interface DIN Rail, Interface DIN Rail |
