Saxby lighting 114573 Bulkhead 2 In 1 MW Sensor
Product Information
Specifications:
- Product Name: Bulkhead 2-in-1 MW Sensor
- Model Number: 114573
- Manufacturer: UK Manufacturer – BH17 7BY, EU Manufacturer – Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg
- Website: www.saxbylighting.com
Product Usage Instructions
Unpacking and Inspection:
Upon receiving the product, carefully unpack and inspect for any isible damage. If any damage is found, contact customer support immediately.
Installation:
Follow the installation instructions provided in the manual. Ensure the product is installed securely and according to the recommended guidelines to prevent any accidents.
Operation:
Before using the product, make sure to read the user manual thoroughly. Follow the operating instructions to ensure safe and satisfactory operation of the Bulkhead 2-in-1 MW Sensor.
Maintenance:
Regularly inspect the product for any signs of wear or damage.
Clean the sensor periodically to maintain its functionality. Refer to the manual for specific maintenance instructions.
Bulkhead 2-in-1 MW Sensor
114573
Thank you for purchasing this product. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference.
- Max Load 20W (LED)
- Operating Temp -20°C – +40°C
- Connection Type Quick Connector
- Sensor Type Microwave
- Mounting Height 6m Max.
- Control Type ON/OFF/STEP-DIM
Dimensions
WARNING: Risk of electric shock!
- Isolate the mains power before proceeding.
- Turn off the mains power before performing inspections, installation, or removal
- Verify that the supply voltage is correct by comparing it with the luminaire label information
- It is the responsibility of the installer to ensure installation is suitable for the total load of the product(s). The supply cable, fuses/circuit breakers must be correctly rated for the electrical load and considering for any transient inrush currents that may occur.
- Do not perform insulation strength or resistance tests on installed products. connected
Installation Procedure
Default Setting: Daylight sensor disabled; Sensitivity 100%; Hold time 5s; Standby 0%
CONTACT
V1 26/08/2024
UK Manufacturer: BH17 7BY
EU Manufacturer: Briliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
www.saxbylighting.com
Frequently Asked Questions
- Q: Can the sensor be adjusted for sensitivity?
- A: Yes, the sensor sensitivity can be adjusted according to your needs. Refer to the user manual for detailed instructions on adjusting the sensitivity settings.
- Q: Is the product suitable for outdoor use?
- A: Yes, the Bulkhead 2-in-1 MW Sensor is designed for outdoor use. However, ensure it is installed in a suitable location protected from direct exposure to harsh weather conditions.
- Q: How can I reset the sensor if it malfunctions?
- A: To reset the sensor, follow the reset procedure outlined in the user manual. Typically, this involves turning off the power source for a few seconds and then turning it back
Documents / Resources
 |
Saxby lighting 114573 Bulkhead 2 In 1 MW Sensor [pdf] Instruction Manual 114573 Bulkhead 2 In 1 MW Sensor, 114573, Bulkhead 2 In 1 MW Sensor, Sensor |