SATECHI ST-BTSX Slim Bluetooth Keyboard User Manual

To turn the Keyboard on or off, move the switch on the top of the device to the “on” position. The power indicator turns green for – 3 seconds and then turns off.

PAIRING YOUR DEVICES

Press and hold Fn Key and one of Bluetooth Keys for —3 seconds to assign a device to it. White LED Light should start Blinking.
On the host device, look for “Slim X1 Keyboard” in the Bluetooth Setting, choose “Connect” to pair. The white LED will stop blinking, indicating a successful pairing. Repeat process to add up to 3 Bluetooth devices.

Note:

After 30 minutes non-operation, the keyboard will go to sleep mode. Please press any key to wake up.

Switch between devices by pressing Fn + 1, 2 , and 3 to switch devices.
For buttons Fl — F12 press the “Fn” key with the key to enable the function.

LED INDICATORS

On/Off – turns green for 4s and turns off.
Low Battery – flashes green when it’s low battery.

Charging – turns red when it’s charging.
Fully Charged – turns green and stays green.

Press
To swap between Media keys and F-Keys. The white LED light gets brighter indicating FN lock is enabled.

BACKLIT

There are 10 backlight levels.You can change the backlight levels at any time by pressing
Note: The backlit turns off when the keyboard battery is low.

CHARGING YOUR KEYBOARD

When the battery is low, the power indicator will flash green. Connect the keyboard to a computer or USB wall adapter using the included USB-C charging cable.
Charge the keyboard for 2 to 3 hours, or until the red charging LED light turns green. The keyboard can be used either wired or wirelessly while charging.

WIRED MODE

Press Fn + to activate the wired mode when USB-C cable is connected. The power LED light turns green. Press Fn +1-3 button to switch back to Bluetooth mode.

HOT KEY FUNCTION & SUPPORT TABLE:

	MAC OS FUNCTION	iOS FUNCTION
	Decrease Display Brightness	Decrease Brightness
	Increase Display Brightness	Increase Brightness
	Spotlight Search	Spotlight Search
	App Switcher	App Switcher (iPad only)
	Decrease Keyboard Backlit	Decrease Keyboard Backlit
	Increase Keyboard Backlit	Increase Keyboard Backlit
	Previous Track	Previous Track
	Play/Pause	Play / Pause
	Next Track	Next Track
	Mute	Mute
	Volume Down	Volume Down
	Volume Up	Volume Up
	Eject	Activate Virtual Keyboard
	Fn Lock	Fn Lock

Safety Instructions
Warning: Fire, electric shock, damage to keyboard device could occur if the following instructions are not obeyed

Keep away from microwave radiation source
Do not place heavy objects on this product
No dropping and bending
Keep away from oil, chemical, or organic solvents

FAQS

Can I use this as a wired keyboard
A: Yes, the Slim X1 Keyboard includes USB wired connectivity. Pressing the “FN + EJECT” keys will activate the USB wired mode for the keyboard.
Does the keyboard come with different color light options?
A: Unfortunately, the keyboard is only equipped with a white backlight. However, you are able to cycle through 10 different brightness options.
How long does the battery last on a full charge?
A: The battery life of the keyboard can vary depending on the level of the backlight brightness but the longest the keyboard can last on a full charge is approximately 80 hours.
Why did my keyboard backlight dim/turn off automatically?
A: The backlight will automatically dim after one minute of non-usage. It will also turn off automatically once it reaches low-power mode.
(Green flashing LED = Low-Power Mode)

NEED HELP?

+1858 268 1800

support@satechi.com

FCC

This device complies with part 15 of the FCC results.
Operation is subject to the following two conditions:

This device may not cause harmful interference and
This device must accept any interference received, including interference that may cause undesired

Note: This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1.1. Reorient or relocate the receiving antenna
1.2. Increase the separation between the equipment and receiver
1.3. Connect the equipment into and outlet on a circuit different from that to which the receiver connected
1.4. Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the manufacturer could void the user’s authority operate the equipment.

CE DECLARATION OF CONFORMITY
Satechi declares that this product is in compliance with the essential requirements and other relevant provisions of applicable EC directives. For Europe, a copy of the Declaration of Conformity for this product may be obtained by visiting www.satechi.net/doc

Documents / Resources

SATECHI ST-BTSX Slim Bluetooth Keyboard [pdf] User Manual
ST-BTSX, STBTSX, ZE9-ST-BTSX, ZE9STBTSX, ST-BTSX Slim Bluetooth Keyboard, ST-BTSX, Slim Bluetooth Keyboard

References

User Manual

PACKAGING CONTENT

SPECIFICATIONS

SYSTEM REQUIREMENTS

FUNCTIONS

ON/OFF