Single Axis Stabilizer
Instructions
R15 Single Axis Stabilizer
Product Overview
1.Stab山zer 2. Telescopic Stick 3.Rmote 4.Powe Botton\Shutter 5.LED |
6.Tripod Stand 7.Power Botton 8.Charging Port 9.Roller Lock 10.Mobile Phone Clip |
Bluetooth remote Control
Step 1: On your phone, tap Settings > Bluetooth, and then turn on the Bluetooth.
Step 2: Hold down the shutter button (about 2s) until indicator light starts flashing to turn on the remote control.
Step 3: Once the Bluetooth name of “Selfie” appears in the display, select it and tap “pair”.
Step 4: Press the Shutter button to take photos.
Step 5: Hold down the shutter button (about 3s)until indicator light goes out to turn off the remote control.
Video Tutorials
Please scan the code for video tutoials.
https://go.plvideo.cn/front/video/view?vid=087fcea12e36c1b6248492caf647e34f_0
Stabilizer
Stepl.Unlock the Roller lock and place the stabilizer on a horizontal table with tripod op
Step2:Put the mobile phone into the mobile phone clip and adust the position of the mobile phone until it can rotate naturally to close to the horizontal position.
*Before turning on the power supply of the stabilizer, you must turn the roller lack ta the unlocked position first, otherwise thestabilizer may be damaged.
FCC Warning Statement
Changes ar madifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been ested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to rovide reasonable protection gainst armful interference in aesidential installation. This equipment generates uses and can radiate radio freuency energy and, if not installed an used in accordance it the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to orrect the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced
Thanks for your support !
Certificated
Documents / Resources
![]() |
Sanyk R15 Single Axis Stabilizer [pdf] Instructions R15, 2A7Y6-R15, 2A7Y6R15, R15 Single Axis Stabilizer, R15 Stabilizer, Single Axis Stabilizer, Axis Stabilizer, Stabilizer |