R15 Single Axis Stabilizer

Product Overview

Step 1: On your phone, tap Settings > Bluetooth, and then turn on the Bluetooth.

Step 2: Hold down the shutter button (about 2 seconds) until the indicator light starts flashing to turn on the remote control.

Step 3: Once the Bluetooth name "Selfie" appears in the display, select it and tap "Join" or "Pair".

Step 4: Press the Shutter button to take photos.

Step 5: Hold down the shutter button (about 3 seconds) until the indicator light goes out to turn off the remote control.

Video Tutorials

Please scan the QR code for video tutorials.

Stabilizer Setup

Step 1: Unlock the Roller lock and place the stabilizer on a horizontal table with the tripod stand on the bottom.

Step 2: Put the mobile phone into the mobile phone clip and adjust the position of the mobile phone until it can rotate naturally to a near-horizontal position.

Important Note: Before turning on the power supply of the stabilizer, you must turn the roller lock to the unlocked position first. Otherwise, the stabilizer may be damaged.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Parts List

• 1. Stabilizer
• 2. Telescopic Stick
• 3. Remote
• 4. Power Button/Shutter
• 5. LED Indicator
• 6. Tripod Stand
• 7. Power Button
• 8. Charging Port
• 9. Roller Lock
• 10. Mobile Phone Clip