samsara logoVG34
INSTALL GUIDE — HEAVY DUTY VEHICLES

APPLICABLE FOR 6-PIN AND 9-PIN CONNECTORS

samsara VG34 Real Time location Tracker

samsara VG34 Real Time location Tracker - 1

Locate the vehicle’s diagnostic port and detach it from its original location.

samsara VG34 Real Time location Tracker - 2

Connect the Samsara cable. The vehicle’s diagnostics remain accessible via the unconnected port.

samsara VG34 Real Time location Tracker - 3

Fasten unconnected diagnostics port to vehicle’s original port location.

samsara VG34 Real Time location Tracker - 4

Plug the Samsara cable gateway connector into the gateway. It will click when fully inserted. Remove the rubber safety cover on the USB port to connect the USB plug into the gateway. For best results, do not cross cables or wrap around the gateway.

  samsara VG34 Real Time location Tracker - 5

Fasten connected gateway in a secure position. Verify the gateway indicator light turns green, this could take 1–3 minutes.
samsara.com/support  

Documents / Resources

samsara VG34 Real Time location Tracker [pdf] Installation Guide
VG34, Real Time location Tracker

Leave a comment

Your email address will not be published. Required fields are marked *