SALTO Wall Reader Keypad Entry System
Card Reader Installation Guide
Installation
GANG ELECTRICAL STANDARD BOX
Maintenance
Dampen a lint-free cloth or cotton swap with alcohol. Gently rub the cloth back and forth across the sensor. Repeat the process once or twice as needed. Visually observe that no residual solution remains on the sensor, especially the edges.
Caution: Harsh and abrasive materials are not recommended for cleaning sensors.
Electrical Characteristics
Operation Conditions
| Temperature WRD0B – WRD0S – WRD0BK |
-35~66°C |
| Temperature WRD0J – WRD0GK – WRD0JK |
-25~66°C |
| Temperature WRD0BF – WRD0JF |
-20~66°C |
| Humidity |
35~85% |
Installation Example
Installation Example with RJ45
Minimum distance between readers 20in (50cm).
|
Signal |
Light | Time | Buzzer |
Time |
| Card / finger rejection |
Red |
1 sec |
High pitched 50/50 |
1sec 3sec |
| Privacy or emergency status |
Red 5x(50/50×3 + off 300) |
3 sec |
High pitched 5x(50/50×3 +off 300) |
0,3sec |
| Standard opening |
Green |
1 sec |
Low pitched |
0,2sec |
| Standard locking |
Red |
0,5 sec |
Low pitched |
2,4sec |
| Open plus office |
Green 400/200 |
2,4 sec |
High pitched/Low pitched 400/200 |
Cont. |
| CLR Button |
Orange |
Cont. |
High pitched |
450msc |
| Reset |
Orange 50/100 |
450msc |
Low pitched 50/100 |
Cont. 100 |
| Waiting for card / finger |
Blinking green 500/500 |
Cont. |
Low pitched 500/500 |
msec |
| Card / finger processing |
Blinking yellow 50/50 |
100msc |
Low pitched 50/50 |
1 sec |
| Successfully processed card / finger |
Green |
1 sec |
Low pitched |
|
UL Statements
Tested by UL with Mifare (DESFIRE, ULTRALIGHT C) and HID iCLASS RFID communication, and with Mobile APP (JustIN Movile version 2.x) through Bluetooth version 4.2. Minimum Operating System version for Android: 4.3 or later and for iOS: 10.0 or later. A means of verification shall be employed by the user to enable access to the wireless electronic device such as a PIN or biometric feature. The wireless electronic device is not capable of command, control, programming, or any other system manipulation and it is only to be used in the same manner as a physical credential. Wiring methods that shall be in accordance with the National Electrical Code, ANSI/NFPA 70 or CSA C22.1-02 – Canadian Electrical Code, Part 1, Safety Standard for Electrical Installations
UL294 Performance Level
|
FEATURE |
LEVEL |
| Destructive attack |
I |
| Line Security |
I |
| Endurance |
IV |
| Standby power |
Per rating of the power supply |
Comply with ULC-S319 Class I
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Documents / Resources
 |
SALTO Wall Reader Keypad Entry System [pdf] Installation Guide WRDX0A4, Wall Reader Keypad Entry System, Wall Reader, Wall Reader Keypad |
