RYTHMOS SWAP Pad Device
How to Use the Swap Pad
- Read the instructions on the back of the Swap Pad.
- Place the old and new wearable on the . appropriate pad, button side down.
- The LEDs will turn blue when both wearables are correctly placed. 0 Press the center button.
- The LEDs will begin flashing in an alternating pattern to indicate a swap is in progress. B The LED’s will blink green to indicate a successful swap, or red to indicate a failure.
- If they blink red, check Rhythms. It may be a false negative.
- The swap may take 1-2 minutes to complete.
FCC
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. A separation distance of 25 cm must be maintained between this device and nearby persons.
This transmitter must not be co-located or operation in conjunction with any other antenna or transmitter.
Maximum antenna gain of -1dBi This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this devices must accept any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
Documents / Resources
 |
RYTHMOS SWAP Pad Device [pdf] Instructions 1902, 2AWYM1902, SWAP Pad Device, SWAP, Pad Device |
