Rowley I-RTEC4 Tec Automation 6 Channel LED Remote Controller
PRODUCT DIAGRAM
Hand-held 6-channel with percentage
REMOTE SPECIFICATIONS
| Battery Type | CR2450*3V*1 |
| Work Temperature | 14°-122°F |
| Radio Frequency | 433.92M+-100KHz |
| Transmit Distance | >=98.5′ indoor |
WARNING
- INGESTION HAZARD: This product contains a button cell or coin battery
- DEATH or serious injury can occur if ingested.
- A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
- KEEP new and used batteries OUT OF REACH of CHILDREN
- Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
CAUTION
WARNING: Important safety and operation instructions to be read before installation and use.
- This product is intended for indoor use only. Do not expose the remote to moisture or extreme temperatures.
- If the remote becomes less responsive and has a shorter transmission range, please check whether the battery needs to be replaced.
- Use or modification outside the scope of this instruction manual will void the warranty.
- When the battery voltage is too low, the orange LED will flicker during operation.
- Please properly dispose of used batteries and replace them with only the specified battery type.
INSTRUCTIONS
Channel Selection
To change channels on the remote in order to pair with a single or multiple motors
Note: A maximum of 15 motors can be added to one channel. All motors added to the same channel will operate simultaneously.
Follow the motor pairing instructions first before completing the remote settings below:\
Hide Unused Channels
Locking the Remote
Prohibits any programming or settings from being changed on the Remote.
To unlock the remote and allow programming once again, repeat the steps above. For further operations please refer to the motor pairing instructions.
FAQ
- Q: How many motors can be added to one channel?
- A: A maximum of 15 motors can be added to one channel. All motors added to the same channel will operate simultaneously.
- Q: What to do if the remote is locked?
- A: To unlock the remote and allow programming once again, repeat \the steps for locking the remote.
Documents / Resources
 |
Rowley I-RTEC4 Tec Automation 6 Channel LED Remote Controller [pdf] User Manual RTAHR6CV1W, I-RTEC4, I-RTEC4 Tec Automation 6 Channel LED Remote Controller, Tec Automation 6 Channel LED Remote Controller, 6 Channel LED Remote Controller, LED Remote Controller, Remote Controller |
