ROTOLIGHT SmartSoft Box
- The SmartSoft™ Box is compatible with the AEOS 2 and AEOS 2 Pro.
- Update your AEOS 2 or AEOS 2 Pro to the latest firmware www.rotolight.com/support
- You’ll need the Rotolight SmartSoft™ Box, 1x Small 1/4” knob, and 2x Large M8 knobs. TE – if you are using the AEOS yoke you do not need the 2x Large knobs Supplied with the SmartSoft™ Box.
- Turn off the AEOS 2/AEOS 2 Pro and remove the Standard Diffuser or Barndoors if they are installed.
- Attach the SmartSoft™ Box and secure it with a small knob, don’t fully tighten at this point.
- Install the 2x Large M8 knobs and fully tighten them and the small knob.
NOTE – if you have the AEOS Yoke installed now tighten the larger knobs and small knob. - Connect the SmartSoft™ Box control cable to the AEOS 2 / AEOS 2 Pro.
- Turn ON the AEOS 2 / AEOS 2 Pro.
- In CCT press the bottom left icon twice to cycle between the brightness and SmartSoft™ control.
- Used the on-screen slider or left Red Control dial to increase and decrease the amount of diffusion. You are now ready to shoot!
How to uninstall SmartSoft™ Box
- To Remove the SmartSoft™ Box turn OFF the AEOS 2 / AEOS 2 Pro.
- Disconnect the Control cable from the AEOS 2 / AEOS 2 Pro.
- Loosen the 2x Larger knobs
- Remove the small 1/4” knob and then the SmartSoft™ Box
- Now you are ready to attach our other light Modifiers https://www.rotolight.com/product-category/light-modifiers/
Documents / Resources
![]() |
ROTOLIGHT SmartSoft Box [pdf] Installation Guide SmartSoft Box, SmartSoft, Box |