ROGUE Stall Bar Instruction Manual

ROGUE Stall Bar

 IMPORTANT SAFETY INFORMATION

DISCLAIMER:

Resistance training, gymnastics training, and activities at height are potentially dangerous and may lead to severe injury or even death.
Use common sense when training, obtain instruction in the proper execution of movements, and understand your limitations.
This equipment must only be used by competent and responsible persons. Obtaining instruction in appropriate techniques and methods of use is your own responsibility. You assume all risks and responsibilities for all damage, injury or death which may occur during or following incorrect use of this equipment in any matter whatsoever. Rogue Fitness bears no liability beyond the replacement value of the equipment in question.

MISUSE OF THIS PRODUCT CAN RESULT IN SEVERE INJURY.
Both Rogue Fitness and buyer disclaim any express or implied warranty, including, without limitation, warranties or merchant- ability and/or fitness for a particular purpose with respect to the equipment. Buyer assumes all liability to use of equipment.

INCLUDED PARTS

Note: Images not shown at scale

• Top Double Stall Bar
  
• Double Steel Stall Bar
  
• Single Steel Stall Bar
  
• 5/8” x 4” Carriage Bolt
  
• 5/8” x 3” Carriage Bolt
  
• 5/8” Flat Washer
  
• 5/8” Lock Nut
  
• 90” Monster Lite Upright
  
• Wall Mount Bracket
  
• 5/8” x 4.25” Hex Bolt
  
• 5/8” Lock Washer
  
• 5/8” Hex Nut
  

STEP 1 

1. Secure Single Crossmember Stall Bar [1], Double Crossmembers Stall Bar [2], and Top Double Stall Bar [3] to Uprights [8] using 5/8” Carriage Bolts [4,5], 5/8” Flat Washers [6], 5/8” Lock Nuts [7]. Do not fully tighten. If mounting to existing rack or rig skip (2).
   Note: 5/8” x 4” Carriage Bolts [4] for Monster Lite, 5/8” x 3” Carriage Bolts [5] for Infinity.
2. Secure optional Wall Mount Brackets [9] to Uprights [8] using provided 5/8” x 4-1/4” Bolts [10], 5/8” Flat Washers [6], 5/8” Lock Washers [11], and 5/8” Hex Nuts [12]. Fully Tighten all brackets.
3. Full tighten all hardware once all Stall Bar Crossmembers and Wall Mount Brackets are completely installed.
   

WALL MOUNT NOTES

• Mounting hardware not included.
• If you are not confident in your mechanical skills, please seek help of a professional to preform the installation. It is the buyers responsibility to install the Stall Bars in a location and with hardware capable of supporting the aggregate weight of the rack and all the gear mounted or stored on it, and any person using it.
• TEST UNIT FOR STABILITY BEFORE EACH USE.
• CAUTION: PRIOR TO PERFORMING DYNAMIC MOVEMENTS SUCH AS KIPPING PULLUPS, ENSURE THAT THERE IS SUFFICIENT CLEARANCE BETWEEN THE PULL-UP BAR AND THE MOUNTING WALL. USE CAUTION AND DETERMINE IF YOUR ARTICULAR SET UP, BODY TYPE, AND MOVEMENT PATTERN ALLOW SUFFICIENT CLEARANCE. FAILURE TO DO SO COULD RESULT IN INJURY.
  

SCAN FOR INSTRUCTIONS

IRON GAME PROGRAMMING

CUSTOMER SUPPORT

Rogue Fitness • 545 E 5th Ave. Columbus, Ohio 43201 • Customer Service: 614-358-6190 • Team@RogueFitness.com