INSTALLATION INSTRUCTIONS
CHROME UNIVERSAL WASTE PULLOUT

TOOLS REQUIRED:

ESTIMATED ASSEMBLY TIME:

15 MIN

CARE AND MAINTENANCE:

Clean with a damp cloth and wipe parts dry.

* Dependent on unit purchased. If your unit did not come with a basket, you can call Rev-A-Shelf’s customer service team to order one. Part Number: RV814BB-1-CRINSTALLATION INSTRUCTIONS: CHROME UNIVERSAL WASTE PULLOUT
I-RUKD-1121
STEP 1
Determine the position you would like to install your waste container, ensuring cabinet frame or hinges does not interfere with the unit (See Figure 1).STEP 2
Match the frame hole locations with slide hole locations and snap the frame into the slides (See Figure 2). STEP 3
Extend the slides to full extension and use the (4) #8 washers and #8-32 X 3/8” flat head machine screws to secure the frame to the slides (See Figure 3). STEP 4
Place frame in desired position (determined in Step 1) inside the cabinet. Mark and pre-drill screw locations using 3/32” drill bit and #8 x 3/4” truss head deep thread screws (See Figure 4).STEP 5
Attach the uprights to the frame and place trash can in the uprights (See Figure 5).STEP 6
Snap the handle to the front upright. (See Figure 6).
Note: Continue to Step 7 if you have a unit that comes with a rear basket.STEP 7
Line up the basket to back clips on the frame and snap into place (See Figure 6).
Note: Not all units come with a wire basket

12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126

Documents / Resources

REV-A-SHELF RV-8PSC-11-5 20-Quart Soft Close 1 Pull-out Trash [pdf] Instruction Manual RV-8PSC-11-5 20-Quart Soft Close 1 Pull-out Trash, RV-8PSC-11-5, 20-Quart Soft Close 1 Pull-out Trash, Close 1 Pull-out Trash, Pull-out Trash

References

• User Manual