RemotePro Installing Receiver to MB-T304
Installing Receiver to MB-T304
- TURN OFF POWER FROM THE POWER POINT
- View the diagram below and ensure that it matches with the back of
your motor. - Loosen each of the three screws, 1, 2, 3 on the back of your motor.
- Connect the black receiver cable to the 1 screw and ghten.
- Connect the blue receiver cable to the 2 screw and ghten.
- Connect the brown receiver cable to the 3 screw and ghten.
- Turn power back on and ensure the receiver powers up.
- Your two new remotes have been pre-programmed to the receiver.
Press buon 1 on your new remote to ensure it can operate the door.
Note: Please ensure your motor looks like the image below
Coding new remotes
Please Note: Your original remotes will connue to work
- Press the black learn buon inside the receiver located next to the LED light unl the LED illuminates.
- Press and hold any buon on your new remote unl the LED flashes 3 mes.
- The remote is now coded, please test the remote to ensure it can operate the motor.
- If you have more than one new remote, please repeat steps 1-3.
WARNING
- To prevent possible SERIOUS INJURY or DEATH:
– Battery is hazardous:NEVER allow children near batteries.
– If battery is swallowed, immediately notify a doctor. - To reduce risk of fire, explosion or chemical burn:
– Replace ONLY with the same size and type battery
– DO NOT recharge, disassemble, heat above 100° C or incinerate - Battery will cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed inside any part of the body.
Documents / Resources
![]() |
RemotePro Installing Receiver to MB-T304 [pdf] Instructions RemotePro, Installing, Receiver, to, MB-T304 |