radioshack BT09S Bluetooth Audio Receiver With Type-C Input and Car Charger
Introduction
Thanks for choosing our Bluetooth receiver. This device allows you to hear the phone music and call not just from car radio, but also from home speaker. Because of its special structure. Once two parts hooked up and plugged to any USB charging port, its will start charging automatically. Fully charged 2 hours, it will provides up to 7 hours of music playing time or 5.5 hours of talking time. To have a better experience, please read this instruction carefully.
Packing Contents
- Bluetooth Receiver
- User Guide
- Charging Cable
Features
- Advance Bluetooth technology V5.3
- Wireless audio streaming for home speakers or car stereo system
- Dual Battery Charging Solutions with two Touch Spots and Type-C input port
- Dual USB output ports with QC3.0+5V/2.4A(total 30W)
- Built-in 300mAh battery
- Built-in LED light for working status indication
- Full-charge time about 2 hours
- Audio receiver head can work as an independent accessory
- Protection for over-circuit voltage, over heat, short circuit
- Quickly active Siri/Google assistant
Specifications
- Bluetooth Version: V5.3
- Bluetooth ID: BT09S
- Bluetooth Frequency range: 2.402~2.480GHz
- Bluetooth Distance: about 8M (open area)
- Battery Capacity: 300mAh 3.7V
- Charging time: about 2 hours
- Talking time: about 5.5 hours
- Music playing time: up to 7 hours
- Standby time: auto power-off 10 minutes after disconnected
- Size: 98.5*34.4*34.5mm
- Microphone: ∮4.0*1.5mm
- Product weight: 52.4g
- Material: Aluminum alloy + ABS Housing
Compatibility
This device can be paired as a hands-free kit with any compatible Bluetooth-enabled devices. Each time can only connected with one Bluetooth device.
Precautions
Please read all safety instruction warnings carefully before using this product. Improper use of this product may result in damage to this or attached products. To ensure the products work well, please never use this in the following conditions:
- Moist or underwater conditions.
- Conditions near heater or high-temperature service.
- Conditions with direct and strong sunshine,
- Conditions with apt falling
- Never dismantle the product without due permission, otherwise it may nullify the warranty clause.
Appearance
Operation Instructions
Using the music playing function
- Plug the Bluetooth receiver’s 3.5mm male jack into your vehicle’s FM radio or home speaker auxiliary port.
- Long-press and hold on the MFB for 5 seconds, the LED light begins to flash and prompt with “Power on”
- Turn on your Bluetooth enabled devices and search new device named “BT09S”, then pair with this unit.
- Turn on your music, then you can enjoy the crystal audio sounds.
- Press MFB once to Play/Pause if you need it.
Using the hands-free function:
- Press MFB once to answer/Hang off the phone call when there is an incoming call.
- Press MFB and hold 2 seconds to reject the phone call.
- Press MFB twice to redial the last phone call.
- Press MFB and hold 2 seconds during conversation so as to hear the call with the BT09C or the Phone.
Charging the Bluetooth Receiver
- When the battery power is low, the relative prompt will appear and its status will also display on your phone.
- It starts charging when the two parts hooked, plug the USB adapter to the charging port, and it will be fully charged within 2 hours.
Cautions: This device can’t work while charging.
Quick Guide
Power on |
Press MFB and hold for 5 seconds until flashing and prompting you with
“Power on” |
Power off |
Press MFB and hold for 5 seconds until prompt “Power off” |
Play/Pause music |
Press MFB once during music playing |
Answer call |
Press MFB once when there is incoming call |
End call |
Press MFB once during call |
Redial call |
Press MFB twice while standby |
Reject call |
Press MFB and hold for 2 seconds when there is an incoming call |
Adjust the volume |
Press and hold “+”button: increase volume
Press and hold “-” button: decrease volume |
Choose music |
Press “< “ button: Play the previous song
Press “>” button: Play the next song |
Switch phone calls between
BT09S and Phone |
Press MFB and hold for 2 seconds during conversation |
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party.
Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
The equipment complies with FCC Radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Frequently Asked Questions
- Q: Can I use the device while it’s charging?
A: No, this device cannot work while charging. - Q: How do I adjust the volume?
A: Press and hold the + button to increase volume, hold the – button to decrease volume.
Documents / Resources
![]() |
radioshack BT09S Bluetooth Audio Receiver With Type-C Input and Car Charger [pdf] User Guide BT09S, BT09S Bluetooth Audio Receiver With Type-C Input and Car Charger, Bluetooth Audio Receiver With Type-C Input and Car Charger, Audio Receiver With Type-C Input and Car Charger, Receiver With Type-C Input and Car Charger, Type-C Input and Car Charger, Input and Car Charger |