QuickBOLT 17667DF 3 Inch Low Profile Microflashing
Production Infromation
- Locate the rafter and predrill the hole.
- Place a ring of sealant around the bottom of the flashing.
- Position the flashing over the hole.
- Secure the flashing with screws.
- Install the solar panel mount.
- Ensure all components are securely fastened.
Specifications
| Product | 17667DF |
|---|---|
| Application | Asphalt, EPDM, & TPO Roofs |
| Patent Number | 8448407 |
FAQ
- What is the purpose of the Microflashing®?
- The Microflashing® provides a watertight seal to protect the roof from leaks.
- Can this product be used on other types of roofs?
- This product is specifically designed for Asphalt, EPDM, and TPO roofs.
- Is professional installation recommended?
- While the product can be installed by a skilled DIYer, professional installation is recommended for optimal results.
QuickBOLT
- A Division of Quickscrews International Corp
- Low Profile QB1 with 3″ Microflashing® & Miniflashing® for Asphalt, EPDM, & TPO Roofs
- Patent # 8448407
RECOMMENDED MATERIALS
- Rafter locator
- Chalk or a crayon
- Drill with a 3/16” drill bit
- M6 deep socket hex driver
- Tool for separating shingles
- 1/2” wrench
- NO SEALANT REQUIRED
INSTALLATION INSTRUCTIONS
After locating the rafter and predrilling the hole
- Place a ring of sealant around the bottom of the Microflashing® washer
- Place the Microflashing® over the predrilled hole
- Drive the bolt until it compresses the Microflashing®
- Place the L-Foot and Nut
- Insert the Miniflashing® under the shingles
- Tighten the Nut to secure the Miniflashing®
LOW PROFILE QB1 WITH 3” MICROFLASHING® & MINIFLASHING® FOR ASPHALT, EPDM, & TPO ROOFS PATENT # 8448407
Documents / Resources
 |
QuickBOLT 17667DF 3 Inch Low Profile Microflashing [pdf] Installation Guide 17667DF, 17667DF 3 Inch Low Profile Microflashing, 3 Inch Low Profile Microflashing, Low Profile Microflashing, Profile Microflashing, Microflashing |
