Quest Xpointer Waterproof Pinpointer Instruction Manual
Quest Xpointer Waterproof Pinpointer

Product Overview

Product Overview

  • Insert battery: Rotate the battery cap 8 counter clockwise, to open the battery compartment. Insert a new 9V battery (note polarity).
  • Power on/off: Press and hold the upper button 5 , until you hear a sound. Two sounds and the LED-Light 4 indicate, that the pinpointer is ready to search.
  • A metal object is signaled by increasing sound and vibration, the nearer the pinpoint tip and side scan area get to it.
  • Switch between tone+vibration/ tone/vibration by pressing the lower button multiple times.
  • Change the sensitivity level by holding the lower button and pressing the upper button at the same time. The sound indicates the current sensitivity level. 1 to 3 sounds = sensitivity level 1 to 3, permanent sound = level 4.
  • If the XPointer has not been used for 3 minutes or the battery runs low, an alarm tone is played.
  • Keep the O-ring clean and greased.

Quest Logo

Documents / Resources

Quest Xpointer Waterproof Pinpointer [pdf] Instruction Manual
Xpointer Waterproof Pinpointer, Waterproof Pinpointer, Pinpointer

References

Leave a comment

Your email address will not be published. Required fields are marked *