Qu-Bit Electronix Nebulae v2 Wave Terrain
Product Information
Specifications:
- Product Name: Wave Terrain – Wavetable 3D Surface Oscillator
- Compatibility: QuBit Nebulae v.2
- Designer: Collin Russell
- Features:
- LFO Index 1
- LFO 1 Rate
- Pitch Control
- LFO 2 Rate
- Filter Resonance LFO Index 2
- Filter Cutoff Output
- Description: This instrument is a wavetable oscillator that scans three-dimensional surfaces. It includes a low pass filter for additional control. Ported from Neb v.1 by Chris Erin.
Product Usage Instructions
Wavetable 3D surface oscillator For QuBit Nebulae v.2 – By Collin Russell
This instrument is a wavetable oscillator that scans three dimensional surfaces. It includes a low pass filter for additional control. Ported from Neb v.1 by Chris Erin.
Powering On the Device:
Ensure the QuBit Nebulae v.2 is powered on before connecting the Wave Terrain module.
Connecting the Module:
Connect the Wave Terrain module to the designated slot on the QuBit Nebulae v.2 according to the provided manual.
Adjusting Parameters:
Use the controls for LFO Index 1, LFO 1 Rate, Pitch, LFO 2 Rate, Filter Resonance LFO Index 2, and Filter Cutoff Out to customize your sound.
Experimentation:
Explore the three-dimensional scanning capabilities of the oscillator by adjusting parameters in real-time for creative sound manipulation.
Frequently Asked Questions
Q: Can I use Wave Terrain with QuBit Nebulae v.1?
A: No, Wave Terrain is specifically designed for QuBit Nebulae v.2 and may not be compatible with v.1.
Q: How can I reset Wave Terrain to its default settings?
A: To reset Wave Terrain, power off the device, then power it back on while holding down the ‘Reset’ button for 5 seconds.
Documents / Resources
 |
Qu-Bit Electronix Nebulae v2 Wave Terrain [pdf] Instructions Nebulae v.2, Nebulae v2 Wave Terrain, Nebulae v2, Wave Terrain, Terrain |
