How do I install the tires on the RYOBI RY142500 pressure washer using the hitch pins?
To install the wheels on your RYOBI RY142500 Electric Pressure Washer, follow these steps from the assembly instructions: Locate the parts: You will need…
Manuals+ Q&A
Pressure Washer questions & answers
Browse answered questions about Pressure Washer, including setup, troubleshooting, compatibility and maintenance.
Browse topics
Answered questions
Where can I purchase a replacement water inlet pipe or hose for the ENNTAS H7-3DC pressure washer?
To purchase a replacement hose (referred to in the manual as the Water inlet pipe) for your ENNTAS H7-3DC Cordless Pressure Washer, you should…
How do I switch between soap application and rinsing on the Greenworks GPW2500C pressure washer?
To toggle between soap application and rinsing on the Greenworks GPW2500C, you must change the spray tip at the end of the spray wand.…
How do I connect the Costway 18FT Telescoping Spray Wand to a Karcher K4 pressure washer?
To connect the Costway 18FT Telescoping Spray Wand to a Karcher K4 pressure washer, you will likely need a specific adapter. The Costway wand…
Does the oil in the pressure pump need to be non-detergent?
According to the Technical Data section (page 13) of the manual for the Karcher HD G Classic series (HD 7/20 G, HD 8/23 G,…
What are the technical specifications for the male threaded end of the pump inlet fitting insert on the APW2700C pressure washer?
The provided documentation for the AiPOWER APW2700C does not list the specific internal engineering dimensions (outside diameter, thread pitch, or thread type) for the…
Why does the pressure washer continue running when the trigger is released and why is the water pressure low?
Based on the Pulsar PWE2001V manual, your unit is equipped with an Auto Stop System that should automatically shut off the motor when the…
How do I switch the EXCELL VR2522 wand to low pressure mode if the handle is stuck?
According to the EXCELL VR2522 manual, the multi-adjustable spray wand uses a push/pull motion to switch between pressure settings. To engage low pressure mode…
Why does the AR Blue Clean 630 motor not turn on even though the power switch lights up green?
If your AR Blue Clean 630 Series power switch (GFCI) is green but the motor is not running, please check the following based on…
Why are the parts so difficult to remove, and can you provide safety warnings to prevent accidents during disassembly?
It is common for new pressure washer couplings and O-rings to be very tight to ensure a high-pressure seal. To safely remove parts and…
Why does my WHOLESUN 3000PSI pressure washer pulsate and lose pressure when a nozzle is attached?
Based on the WHOLESUN 3000PSI Electric Pressure Washer manual, the pulsation and loss of pressure when a nozzle is attached typically indicate a blockage…
How can I open a professional account with FNA Group to order Simpson products with net payment terms?
To establish a professional account for ordering SIMPSON products or to discuss commercial contracts and payment terms (such as net 7, 14, or 30…
How can I troubleshoot my SurmountWay GHW-3600 pressure washer shutting down, and where can I buy a replacement pull cord?
Based on the SurmountWay GHW-3600 manual, here is guidance for your issues: Troubleshooting Shutdowns Low Oil: This unit features a Low-Oil Auto Shut-Off. If…
Why won't my Cecotec HidroBoost 1400 EasyMove pressure washer start, and why is there no electrical continuity?
If your Cecotec HidroBoost 1400 EasyMove pressure washer is not starting, please check the following troubleshooting steps based on the manual: Check for Pressure…
How do I get a replacement unloader for the BILT HARD THA-0352 gas pressure washer?
To obtain a replacement unloader or other service parts for your BILT HARD THA-0352 Gas Pressure Washer, you should contact the manufacturer's customer support…
My pressure washer stops shortly after starting. What could be the reason?
The information provided in the Nilfisk TITAN X-TRA manual and external support pages offers several reasons why a high-pressure washer might stop during use.…
How do I adjust the power on the Cecotec HidroBoost 3200 Induction Pro?
To adjust the cleaning power and pressure on the Cecotec HidroBoost 3200 Induction Pro, you should use the different Ultrajet nozzles provided with the…
How do I configure the jet output on the nozzle for the Einhell Hypresso 18/24 Li?
To configure the jet output on the Einhell Hypresso 18/24 Li (4140130), you should use the adjustable multifunctional nozzle. While the provided datasheet does…
How can I order an original replacement trigger gun for the Bigzzia YL5650C-150B pressure washer?
To obtain an original replacement trigger gun (referred to as the "pistola a spruzzo" or "trigger gun" in the manual) for your Bigzzia YL5650C-150B,…
How do I remove and replace the black spiral hose on the Fanttik NB8 Nano Pressure Washer?
To replace the hose on your Fanttik NB8 Nano Pressure Washer, follow these steps based on the manual's component layout: Bleed Pressure: Before attempting…
What accessories should be included with the Karcher K2 Compact? I am missing the hose retainer clip for the trigger gun, and the water pressure is very weak. Where can I get replacement parts?
Hello, thank you for your questions. Here is some information regarding the accessories and performance of your Kärcher K2 Compact pressure washer. 1. Included…
Why is my Einhell 4140130 cordless pressure washer not producing foam?
If your Einhell Hypresso 18/24 Li (4140130) is not producing foam, please check the following steps based on the product specifications: Check the Foam…
What type and quantity of oil does this pressure washer use?
Based on the provided manual for the TOTAL 1800W High Pressure Washer, there are no instructions or specifications regarding oil type or quantity. This…
What are the suction pressure and minimum inlet pressure requirements for the BOSCH EasyAquatak 100 pressure washer?
Thank you for your question. The instruction manual for the BOSCH EasyAquatak 100 provides the following information regarding water supply requirements: The manual does…