Polybird-LOGO

Polybird P53 Round End Table

Polybird-P53-Round-End-Table-PRODUCT

Specifications

Product Round End Table
Model P53
Tools Required Screwdriver (not provided)
Hardware Included #8 x 2 1/2″ screws (Quantity: 8)

TOOLS

Polybird-P53-Round-End-Table-FIG- (1)

HARDWARE

Polybird-P53-Round-End-Table-FIG- (2)

Parts Overview

  • Part A – Table Legs (2 pieces)
  • Part B – Table Legs with Crossbrace (2 pieces)
  • Part C – Tabletop (1 piece)

Polybird-P53-Round-End-Table-FIG- (3)

Assembly Instructions

Note before starting: Wait until the whole piece is assembled to tighten the screws completely.

  1. Attaching the Legs: Slide legs of part B into notches on the bottom of tabletop part C using two #8 x 2 1/2″ screws (AA) per leg.Polybird-P53-Round-End-Table-FIG- (4)
  2. Completing the Frame: Repeat step 1 for part A, fitting into notches in the tabletop and in the crossbrace on part B.

Polybird-P53-Round-End-Table-FIG- (5)

FAQ

What tools do I need to assemble the table?

You will need a screwdriver, which is not provided with the hardware.

Should I fully tighten the screws as I attach each part?

No, you should wait until the entire piece is assembled before fully tightening the screws to ensure proper alignment and stability.

How many screws are used for each leg?

Each leg is attached using two #8 x 2 1/2

Documents / Resources

Polybird P53 Round End Table [pdf] Installation Guide
P53 Round End Table, P53, Round End Table, End Table, Table

References

Leave a comment

Your email address will not be published. Required fields are marked *