TIF01 kit—2020 Toyota 79 series Instructions

TIF01 2020 Toyota 79 Series Reverse Camera Integration

1. Plug connector A directly into the back of the head unit
2. Plug connector B & C together
3. Plug Polaris miniature camera into connector D
4. Locate the 28 pin plug in the head unit (See Figure A)
5. There is a GREEN wire from this pin that runs to a coil of black tubing. You should see a clip on the end of the GREEN wiring and this is needs to run to your reverse power.
6. Attach the clip to your reverse power which is a RED wire with BLACK stripe located in the DRIVERS SIDE KICK PANEL OR THE STEP PANEL
7. Put vehicle in reverse to test.

Note: If you do not have the camera plugged in when testing then nothing will happen on the screen

1300 555 514

Documents / Resources

POLARIS TIF01 2020 Toyota 79 Series Reverse Camera Integration [pdf] Instructions TIF01, TIF01 2020 Toyota 79 Series Reverse Camera Integration, 2020 Toyota 79 Series Reverse Camera Integration, Reverse Camera Integration, Camera Integration, Integration

References

• User Manual