INSTRUCTION
MANUAL
Rev01(A)
PIUC08B/PIUC08W
Utility Cart
Contents
Installation
NOTE: Make sure the legs are installed as tightly as possible against the basket.
Connect the legs [B1] and [B2] together, but do not screw in screws. Insert the assembled legs [B1] and [B2] into the basket [A] from the bottom of the basket [A], then tighten the screws [E].
NOTE: Make sure the side poles are installed as tightly as possible against the basket.
Insert four side poles [D]. Align the holes of the side poles [D] with the holes on the legs [B1] and [B2], then secure them with the screws [E].
NOTE: Make sure the side poles are installed as tightly as possible against the basket.
Slide the basket [A] onto the poles already attached, then insert four more side poles [D]. Align the holes of the upper poles with the holes on lower poles, then secure them with the screws [E].
NOTE: If the utility cart is unlevel on the floor, adjust the casters with wrench [I] for leveling.
Repeat step ③ to install two more tiers. Then secure the handles [C] by aligning the screw holes and tightening the screws [E]. Attach the casters [G1] and [G2], hooks [L], and cups [J].
860-00532-00 Rev01
Documents / Resources
 |
Pipishell PIUC08W 4 Tier Rolling Cart [pdf] Instruction Manual PIUC08W 4 Tier Rolling Cart, PIUC08W, 4 Tier Rolling Cart, Rolling Cart |