DDLE801
Leading Edge
Dimmer Controller
Installation Instructions
DDLE801 Leading Edge Dimmer Controller
Devices must be installed in an approved enclosure by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
 |
 |
The manufacturer is not responsible for dimmable lamp selection. Each lamp/dimmer combination must be tested for compatibility prior to installation.
Installation of a home and building automation and control system shall comply with IEC 60364 (all parts). The temperature limits and current-carrying capacities for the communication wires specified in IEC 60364-5-52 shall not be exceeded.
Professional dimmers rated > 1000 W are out of scope of EN 61000-3-2.
© 2022 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
AZZ 386 0622 R19
www.dynalite.com
Documents / Resources
 |
PHLIPS DDLE801 Leading Edge Dimmer Controller [pdf] Instruction Manual DDLE801 Leading Edge Dimmer Controller, DDLE801, Leading Edge Dimmer Controller, Leading Dimmer Controller, Edge Dimmer Controller, Dimmer Controller, Dimmer |
