Installation Instructions
Devices must be installed by a qualified electrician in accordance with all national and local electrical and construction codes and regulations.
x4
x4
x4
RJ12
[1]
IEC Pollution Degree II
[2]
[3][A]
[3][B]
[4]
≤ 10 A/CH ≤ 75 A
[5]
IEC Overvoltage Category III
[6][A]
[6][B]
[7][A]
[7][B]
[8]
[9]
Apply de-rating for electronic and LED loads. The manufacturer is not responsible for dimmable lamp selection. Each lamp/dimmer combination must be tested for compatibility prior to installation.
Professional dimmers rated > 1000 W are out of scope of EN 61000-3-2.
© 2021 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
www.lighting.philips.com/dynalite
AZZ 391 1021 R15
Documents / Resources
 | PHILIPS DLE1210GL Leading Edge Dimmer Controller [pdf] Instruction Manual DLE1210GL, Leading Edge Dimmer Controller, DLE1210GL Leading Edge Dimmer Controller |
 | PHILIPS DLE1210GL Leading Edge Dimmer Controller [pdf] Instruction Manual DLE1210GL Leading Edge Dimmer Controller, DLE1210GL, Leading Edge Dimmer Controller, Edge Dimmer Controller, Dimmer Controller |
