peplink CMO AP One AX
Product Specifications
- Model: LoOE
- Power: 6WHSV
- Dimensions: Standard size
- Weight: Lightweight
Product Usage Instructions
Step 1: Setting Up
Place the product on a flat surface in a well-ventilated area.
Step 2: Powering On
Connect the power source and switch on the device using the power button.
Step 3: Operating the Product
Refer to the user manual for specific instructions on how to use the product efficiently.
Frequently Asked Questions (FAQ)
- Q: How do I clean the product?
A: Use a soft, dry cloth to clean the product. Avoid using harsh chemicals. - Q: Can this product be used outdoors?
A: This product is designed for indoor use only.
Ceiling Mount
Steps:
- Slide the ceiling mount base into the slot on the back of the access point.
- Position the T-Rail on the ceiling mount base as shown in image 3.
- Secure the device by ensuring that the ceiling mount base is hooked onto the T-Rail.
Wall Mount
Steps:
- Determine where the access point is to be placed and mark the location for the two mounting holes.
- Use the appropriate drill bit to drill two 8.1mm diameter and26mm deep holes at the markings and hammer the anchors into the openings.
- Screw the anchors into the holes until they are flush with the wall. Position the mounting bracket over the anchors and secure it to the wall by screwing the included screws into the anchors.
- Place the access point against the wall and slide it onto the mounting bracket.
www.peplink.com
© Peplink, All rights reserved.
Documents / Resources
 |
peplink CMO AP One AX [pdf] Installation Guide CMO, CMO AP One AX, CMO, AP One AX, One AX, AX |
