PDQ 6400 Series Exit Devices Instruction Manual
PDQ 6400 Series Exit Devices

ADJUST FOR DOOR THICKNESS

  • Pin can be moved for 1¾”, 2″ or 2 ¼”
  • Remove clip, move pin to desired location, reinstall clip
    Adjusting Door thickness

HAND TRIM – 6W/6N Only

  • Adjust lever for proper handing
    installation instruction
  • Install lever drive spindle
    installation instruction

INSTALL TRIM

  • Secure trim and exit device to door
  • Trim will always thru bolt to exit device
    • Verify operation of both the trim and the exit device
  • 6T only – Secure handle with mounting screw and finish washer
    installation instruction

REMOVE BACKPLATE

  • Remove retaining clip
  • Remove (4) screws
  • Remove Backplate
    Remove Back Plate

DETERMINE FUNCTION

  • Standard 6W includes conversion kit within escutcheon
  • 6N/6T conversion kit can be ordered separately
    Determine Function

INSTALL NEW FUNCTION

  • nstall desired function
    • 08 Function: Spring engages beneath boss on locking mechanism. Spring spacer must be installed on inside of spring before tightening screw
      Installation instruction
    • 09 Function: Extension spring to go around boss on locking mechanism
      PDQ 6400 Series Exit Devices Instruction Manual Installation instruction
  • For 6W Only: Install unneeded function into storage location
  • Reinstall backplate and retaining clip

 

Documents / Resources

PDQ 6400 Series Exit Devices [pdf] Instruction Manual
6400 Series, 6300 Series, Exit Devices, 6400 Series Exit Devices

References

Leave a comment

Your email address will not be published. Required fields are marked *