pdq 6300D Dummy Device
PREPARE DOOR
- Prepare door and frame according to template.
SIZE DEVICE
- Standard lengths are for 36″ or 48″ door. Device must be cut for other lengths.
- Mark length with tape – length equals device size minus desired door size (for 30″ door = cut 6″ off 36″ device) ensuring a square cut.
INSTALL DEVICE
- Install device with 2 screws.
- Device can be surface mounted to the door, optional sex nuts are available.
Mounting Options: Reinforced Steel or Aluminum Door Surface Mount: Drill/Tap push side for 1/4-20 Solid Wood Door Drill 1/8″ Pilot Hole for #10 Wood Screw All Others Use optional Sex Bolts. Drill push side with 9/32″ drill bit. Drill pull side with 3/8″ drill bit.
INSTALL END CAP
- Slide end cap into rail. Ensure rail is level. Mark the centers of the slots.
- Remove end cap then drill holes using the chart from Step 3.
- Reinstall end cap and fasten with screws.
Documents / Resources
 |
pdq 6300D Dummy Device [pdf] Instruction Manual 6300D Dummy Device, 6300D, Dummy Device |
