PCI RACE RADIOS Polaris PRO R GPS Elite and HDS Live GPS Bracket Installation Guide

PROVIDED HARDWARE

• 4 Push Pins
• #6-32 x 1″ SS Phillips Pan head screw
• #6-32 Zinc NY lock Nut
• #6 Zinc Washer

TOOLS NEEDED

• Drill
• Oscillating Multi tool with blade
• 1/4“ Drill bit
• Silver Sharpie

INSTRUCTIONS

1. Remove cover on dash to expose the factory Ride Command mounting hole.
   
2. Place bracket on dash where it will be mounted.
   
   a. Mark the 4 mounting holes with a silver sharpie. There are two on top and two on the bottom.
   
   i. Use a 1/4” bit and drill all 4 holes
   
   b. Mark and cut dash so the back of your GPS can recess into the hole.
   
3. Mount GPS to bracket.
   NOTE: the Elite model has 4 individual covers in each corner and the HDS Live has a bezel around the whole GPS that needs to be removed to expose the through holes.
4. Run power to GPS and connect.
5. Secure bracket to dash with 4 push pins.
   

Symbols

5 62-427-8177
 www.pciraceradios.com

Documents / Resources

PCI RACE RADIOS Polaris PRO R GPS Elite and HDS Live GPS Bracket [pdf] Installation Guide PRO R Elite, HDS Live, Polaris PRO R GPS Elite and HDS Live GPS Bracket, Polaris PRO R GPS, Elite and HDS Live GPS Bracket, HDS Live GPS Bracket, Live GPS Bracket, GPS Bracket

References

• User Manual