Oumeike B04-25FLB-P003-B LED Flood Light With Motion Sensor
LED Flood Light with motion sensor
Thank you for purchasing our products. To ensure a better shopping experience, please follow the instructions for use step by step.
WARVING
- The LED module can’t be replaced, you need to replace the entire lamp if it damaged or reach the service life.
- If the wire is damaged, the lamp can no longer be used and needs to be scrapped.
- If the casing breaks or water enters, the lamp can no longer be used and needs to be scrapped.
- Do not stare at the LED light-emitting surface closely for a long time, to prevent the hurt of the eye.
- Under no circumstances should the luminaire be covered by a thermal pad or similar material.
- The Lamp requires professional electrician to install.
- The IP66 waterproof grade is just for rainproof, the lamp can not be immersed in water, otherwise it may cause leakage.
- The terminal block is not included. (Please prepare the terminal block according to your actual needs)
Component and structure diagrams
How to install
- Step 1: Drill two mounting holes according to the distance of the screw holes on the bracket.
- Step 2: Put expansion screws in the prepared mounting holes, then place the bracket in the mounting position and fix with screws.
- Step 3: Adjust the direction of light and the inspection range of the sensor as needed.
- Step 4: Connect the wires. Plastic-clad aluminum
- Step 5: Adjust the TIME, LUX switch at the bottom of the sensor according to actual needs. (Please confirm which sensor you purchased, and then adjust it according to the instructions)
Parameter
Lighting Time Switch: Press the switch 5S-45s-120s-600S cycle.- The indicator light will stay on when switch to corresponding mode.
Working Mode Switch: Press the switch Sun-Moon cycle.
Day mode: Lights up during the day and night, 24 hours working.
Night Mode: Only work at night.- The indicator light will stay on when switch to corresponding mode.
Notification
The detection distance depends on the ambient temperature. If the ambient temperature is close to or higher than the human body temperature, the sensing detection distance will become shorter.
This means you need to get closer to this light. Conversely, if the ambient temperature is lower than the human body temperature, this sensing detection distance will be farther.
Routine maintenance
- To ensure better lighting, please clean the fixtures regularly.
- Before maintenance, make sure the power is disconnected.
- To avoid damage of the lamp, please do not clean it with chemicals.
Manufacturer: Shenzhen Oumeike Lighting Technology Co., Ltd.
- Address: No. 19-20,Anye Road, Yuanshan Street, Longgang District,
- Shenzhen, Guangdong, China E-mail: infoous@163.com
CET PRODUCT SERVICE LTD.
- UK REP Beacon House Stokenchurch Business Park, Ibstone Rd,
- Stokenchurch High Wycombe HP14 3FE UK
- Tel:+447419325266 E-mail: info@cetproduct.com
Documents / Resources
 |
Oumeike B04-25FLB-P003-B LED Flood Light With Motion Sensor [pdf] Instruction Manual B04-25FLB-P003-B, B04-25FLB-P003-B LED Flood Light With Motion Sensor, LED Flood Light With Motion Sensor, Flood Light With Motion Sensor, Motion Sensor |