OptiTrack Slim 3U Capturing Fast Moving Objects

Specifications
- Product: Slim 3U
- Compatibility: OptiHub 2, generic USB hub or port
- Sync Method: RCA Sync Break-Out Cable
- Lens Compatibility: M12 Lens, CS Lens, C Lens
- Optional: Filter Plug or Filter Switcher
Install Software
Download and run the latest software installer on your host computer. Please visit www.optitrack.com/support/downloads/ for a list of compatible software.
Setup Camera Network
Single Camera
Connect the Slim 3U camera to a USB port of an OptiHub 2 or generic USB hub or port.

Multiple Cameras:
Multiple OptiTrack cameras may be synchronized for greater precision, via a RCA Sync Break-out Cable
Note: Multiple Slim 3U plugged into an OptiHub 2 will not sync with each other (unlike OptiTrack’s Flex 3 and Flex 13 USB cameras)
RCA Sync Break-Out Cable
- When using Slim 3U cameras, all cameras in the sync chain must be of the same type. Mixed sync environments are not supported.
- Plug in RCA Sync Break-Out Cable to each camera (see Diagram 2).
- Connect master device’s “out” connector to slave camera’s “in” connector using a RCA Sync Break-Out Cable (sold separately).
- Initiate camera synchronization via software.

Install Lens (Optional)
Thread the lens into included lens holder/adapter until finger tight.
- PCB-only Slim 3U camera (no case) only supports M12 lenses.
- Mounting an M12 lens on a Slim 3U camera with the case requires a CS to M12 adapter.
- OptiTrack’s M12 lenses should be installed with the included Wave Spring for secure focusing.
- CS lenses can be installed directly onto the Slim 3U case.
- C lenses require a CS to C adapter before mounting onto the camera case.

Install Filter Plug or Filter Switcher (Optional)
- Insert Filter Plug/Filter Switcher into slot on the side of M12 lens holder (right-side slot if camera is upright and facing you).
- Tighten set screw on right side of plug.
- If Filter Switcher: Plug two-pin connector into jack at top rear of board. Route wire through notch at top of board.
Note: Perform steps in reverse to uninstall Filter Plug/Filter Switcher.

Technical Notes
- Make sure all USB hubs used with the device are externally powered (plug into wall).
- For best performance, use the device with OptiTrack’s OptiHub 2.
- Users must have administrative privileges to install the USB drivers on their computer.
- Important: Slim 3U cameras must have a lens installed to track and capture video.
Need help?
Call technical support at 1-888-965-0435 or e-mail us at support@optitrack.com.
© 2025 NaturalPoint Inc. All rights reserved. Subject to change without notification. 08/25
Frequently Asked Questions
Can I mix different types of cameras in the sync chain?
How do I uninstall the Filter Plug/Filter Switcher?
Documents / Resources
![]() | Slim 3U Capturing Fast Moving Objects |
References
- OptiTrack - Motive Downloads - Software, motion capture data (BVH, C3D and FBX) and morewww.optitrack.com
- User Manualmanual.tools

