OPENBUILDS CP0010 BLOX Layout Developer Toolbox
Layout Information
SPECIFICATIONS
PRECAUTIONS
- Ensure all connections are secure and free from shorts.
- Check that no exposed wires touch each other or any conductive surfaces.
- Wire power supply units (PSUs) with correct polarity.
- Adhere strictly to voltage and current ratings on BLOX and in the documentation,
- Never perform wiring tasks while the system is powered on,
- Use antistatic measures like wrist straps or mats.
- Avoid exposing BLOX to water, moisture, excessive heat, or harsh environments.
- Do not use BLOX for critical safety or security applications.
FCC Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Frequently Asked Questions
- Q: What should I do if the device causes interference to my radio or TV reception?
A: Follow the interference troubleshooting steps provided in the manual to mitigate the issue. If problems persist, seek professional help. - Q: Can I use a different antenna with the device?
A: To maintain compliance with FCC guidelines, it is recommended to use only the supplied antenna for operation.
Documents / Resources
 |
OPENBUILDS CP0010 BLOX Layout Developer Toolbox [pdf] Instruction Manual CP0010, CP0010 BLOX Layout Developer Toolbox, BLOX Layout Developer Toolbox, Developer Toolbox |
