Wire Harness Layout
Instructions
Instructions
WIRE HARNESS LAYOUT – LED SHROUDS
(DRL)
Wire Harness Layout
- Connect to positive (12v+) of the daytime running light
- Connect to negative (-) of the daytime running light
- Connect to the Positive (12V+) of the low-beam signal*
*THIS WILL DIM THE DRL WHEN LOW-BEAM IS ACTIVATED. IN CASE OF HID/XENON WITH A BALLAST, THE +BEFORE THE BALLAST NEEDS TO BE USED.
Documents / Resources
 |
RETROFITLAB Wire Harness Layout [pdf] Instructions Wire Harness Layout, Harness Layout, Layout, Wire Harness, Harness |
