Owner’s Manual
Instruction of RF6709
|
Issue Department：Bedding Division | Date： | Author： |
| ystem Instruction | Author： | ||
| Instruction of RF6709 | Edition： | 1.1 | |
| Page 1 of 4 | |||
Item
1.1 Head up 1
Press and hold HEAD UP button of remote, head actuator moves out, stop when released；
1.2 Head down 2
Press and hold HEAD DOWN button of remote, head actuator moves in, stop when released；
1.3 Foot up 3
Pressa and hold FOOT UP button of remote, foot actuator moves out, stop when released;
1.4 foot down 4
Press and hold FOOT DOWN button of remote, foot actuator moves in , stop when released；
When moving to flat position, lumbar actuator and tilt actuator move first, after 500ms, head and foot actuators start moving;
1.5 ZEROG 5
Click zeroG button, then actuator will move to zeroGposition, during the movement, click any button to stop it;
1.6 Light 6
Click light button, open the light(WHITE LED) on the remote.
1.7 Flat 9
Click FLAT button, the bed goes flat, stop when click any button during the process of going flat；
1.8 Memory location 7 8
Click memory location to set the bed to the setted location.
FCC：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This Equipment generates,uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a Particular installation.If thise quipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IC RSS warning
This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device.
ISED RSS Warning:
This device complies with Innovation,Science and Economic Development Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Documents / Resources
 |
OKIN REFINED RF6709 9 Button Remote Control [pdf] Owner's Manual 2AVJ8-RF6709, 2AVJ8RF6709, rf6709, RF6709 9 Button Remote Control, RF6709, 9 Button Remote Control, Remote Control, Control, Remote |