OFFROAM 2019-2022 Mounting Base Installation Guide

Mounting Base Installation Instructions
Subaru Ascent 2019-2022

Contents hide

1 WARNINGS

2 COMPONENTS

3 POSITIONING

4 Documents / Resources

4.1 References

WARNINGS

Do not mount accessories in front of or near the path of airbag deployment.
Check vehicle compatibility before install to avoid damage to the vehicle mount point.
Designed to work with OEM dashboard only, not compatible with aftermarket modifications.
Do not use with 3rd party extention arms. Adhere to our phone weight limits.
Mount electronics away from airflow to prevent heat damage.

Self-installation instructions and advice are provided for your convenience. It is your responsibility to determine if you have the knowledge, skills, and physical ability required to properly perform an installation. Offroam shall have no liability for damage or injury resulting from the installation or use of any Offroam or third party products. It is your responsibility to ensure that all products are installed in adherence with local laws and regulations and in such a manner as to allow a vehicle to be operated safely and without distraction. Offroam product warranties do not cover the installation, removal or re-installation of any product.

COMPONENTS

Using the L-key provided, slightly loosen the screws to ensure the inner plate moves.
Do not fully remove the screws – keep about one thread engaged.
Position mounting base into the upper outer corner of the center console air vent. Ensure the tabs on the rear mounting base plate engage the lip behind the air vent bezel (01).
Using the L-key, hand tighten the screws until the mounting base has a snug ﬁt.
To ensure the best ﬁt possible, hold mounting base while tightening.