NuPhy Halo96 V2 Wireless Mechanical Keyboard
HAL096
Quick Guide
System Selection
Connection Mode Selection
* In the wired mode, it is necessary to use a data cable to connect with the device.
Wireless Device Connection
Long press 3 seconds to enter pairing mode, short press to switch between devices. Plug the 2.4Ghz receiver into your computer before pressing FN + 4.
Backlight Settings
- FN + < Backlight effect switching /
- FN + > Backlight color switching /
- FN + ~/~ Brightness + –
- FN + </> Backlight speed – +
Auxiliary lights Settings
- FN + M + < Auxiliary lights effect switching
- FN + M + > Auxiliary lights color switching
- FN + M + ~/v Auxiliary lights brightness + –
- FN + M + </> Auxiliary lights speed – +
- FN + M + ? Auxiliary light groups on/off control
Sleep Mode Setting
FN+T the See Mode ON off A 0/OFF
* If there is no operation on the keyboard, it will turn off the light and enter sleep mode after 6 minutes.
Battery Indicator
FN + I Enable/ disable permanent battery level display
Factory Reset
FN + { Long press for 3 seconds to restore factory Settings
The Screenshot Shortcut
Section screenshot
Full screen screenshot
Open Snipping Tool and take a screenshot
Keyboard shortcut for print screen
VIA Keymap Configurator
This keyboard is compatible with VIA, a third-party open source software used to configure its keymaps, light effects and macros. To obtain the latest version of VIA,
visit: nuphy.com/pages/-console. If VIA fails to detect your keyboard under the wired mode, feel free to contact us for technical support.
Mac Mode: LAYER 0/1
Win Mode: LAYER 2 / 3
Documents / Resources
 |
NuPhy Halo96 V2 Wireless Mechanical Keyboard [pdf] User Guide Halo96 V2 Wireless Mechanical Keyboard, Halo96 V2, Wireless Mechanical Keyboard, Mechanical Keyboard, Keyboard |
