NORDOST QNET Stand Network Switch Instruction Manual
QNET STAND
Easily support your QNET NETWORK SWITCH with Sort Kones for optimum performance with resonance control.
COMPONENTS
CENTER PIEC
LEGS (x3)
RING
ASSEMBLY
Place center piece flat on a table with the pin side up.
Slide 3 legs onto pins with the slot for the rubber gasket and the Sort Kone depressions facing down
Carefully flip the stand over so that the legs do not slide off.
With the grooves facing up, take the rubber ring and stretch it with both hands so that it can snap into the groove on one of the legs.
Repeat with the second leg, and then the third.
ATTACHING
Lay the QNET upside down (with the vents facing down) on a flat surface. Lay the Stand on it so the legs fall symetrically, or approximately where you would like them.
Hook two of the legs onto the edge of the unit and stretch the third so that it can snap on and secure the Stand to the QNET.
FINISHING
Adjust so that the spaces between the legs and the center piece are about even.
Flip the unit over and set on three Sort Kones so the tips fit into the depressions.
See www.nordost.com/downloads.php
for more language options
Documents / Resources
 |
NORDOST QNET Stand Network Switch [pdf] Instruction Manual QNET Stand Network Switch, QNET Stand, Network Switch, Switch |
