NHP CSPC2LD10150C Meter Isolator
Specifications
- Product: Meter Isolator
- Configuration: 1 Pole / 3 Pole
- MCB Ratings: 40A/50A/63A
- Current Fault Rating: 6kA/10kA
Product Usage Instructions
- Refer to Steps 1-1 to 1-11 on pages 2-5 for the installation procedure.
- Ensure de-energization before starting the installation process.
- Follow the wall mounting dimensions provided in the manual for both 1-Pole and 3-Pole configurations.
- Use the necessary tools and consumables as listed in the manual.
- Assemble the terminal pins to the MCB following the instructions.
- Terminate cables into terminal pins with a maximum size of 16 mm2.
- Complete the installation by assembling the top cover.
- Refer to Steps 2-1 & 2-2 on pages 5-6 for operational guidelines.
- Ensure the lockdown operation is set to the OFF position before proceeding.
- Follow the instructions for adding a padlock or wire seal for security measures.
overview
Part Number
CSPC2LDx 1 Pole KIT (supplied)
CSPC4LDx 3 Pole KIT (supplied)
TOOLS REQUIRED
CONSUMABLES (not supplied)
INSTALLATION
- Wall mounting dimensions
- Remove top cover from the assembly
- Remove MCB with lockdin attachment
- Remove the lockdin attachment from MCB
- Assemble terminal pins to MCB
- Reassemble the locking attachment to MCB
- Knock-out Ø22mm holes on the enclosure base for rear cable entry
- Wall mount enclosure base
- Install MCB lockdin assembly
- Terminate 1-10 cable into terminal pins (maximum 16 mm2)
- Assemble the top cover
OPERATION
- Lockdin operation
- Adding padlock/wire seal
CONTACT
- AUS 1300 NHP NHP nhp.com.au
- NZ 0800 NHP NHP nhp-nz.com
- NHP Electrical Engineering Products Pty Ltd A.B.N. 84 004 304 812
- CSPCLDx-IN-001-EN © Copyright NHP 2025.03.18
FAQ
- Q: What should I do if the MCB trips frequently after installation?
- A: If the MCB trips frequently, it could indicate an overload or a fault in the electrical circuit. Check the connected loads and wiring for any issues. If problems persist, consult a qualified electrician for further assistance.
- Q: Can I use this product for outdoor installations?
- A: The Meter Isolator is designed for indoor use. For outdoor installations, ensure proper weatherproofing and protection against environmental elements.
- Q: What is the recommended maintenance schedule for this product?
- A: Regular inspection of connections, cables, and overall condition is recommended. Any signs of wear or damage should be addressed promptly. Consult the user manual for specific maintenance guidelines.
Documents / Resources
 |
NHP CSPC2LD10150C Meter Isolator [pdf] Installation Guide CSPC2LD10140C, CSPC2LD10150C, CSPC2LD10163C, CSPC2LD10163D, CSPC2LD6163C, CSPC2LD6163D, CSPC4LD10350C, CSPC4LD10363C, CSPC4LD6363C, CSPC4LD10363D, CSPC2LD10150C Meter Isolator, CSPC2LD10150C, Meter Isolator, Isolator |